Installation of Timbren Suspension Enhancement on 1994 Toyota Pickup

Question

Question:

I have a 1994 Toyota 1/2 ton pickup 4 cylinder 5 speed standard transmission base model. I think the suspension part TDVR05091 might help my aging leaf springs. I got under the truck and checked the location and found the original rubber stop over the axle. It is an elongated pyramid rubber thing with a bolt or screw on each side into the channel metal frame. There is no access to attach a nut onto any bolt that might pass through the frame. I guess my question is will this part simply attach to my frame using the same holes and screws? Thanks

asked by: Ethan C

0

Expert Reply:

The Timbren Suspension Enhancement System # TDVR05091 is designed to bolt right onto your 1994 Toyota pickup. This will replace your truck's current bump stop by bolting to the frame in the same location.

You should know that the Timbrens are to be used with a suspension in good working order and are not to be used in place of faulty springs. The springs are for suspension enhancement, not replacement.

expert reply by: Charles S

0

Answer 1

The Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle #F2304 is designed to fit the Tacoma when the leaf spring is on top of the axle. Unfortunately, these air bags and others like it will not fit with the leaf spring under the…

view full answer...

Answer 2

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

If you are considering Timbrens like the #TDR1500DQ and the SumoSprings like the #SSR-307-47 for your 2022 Ram 1500 4x4, I recommend the SumoSprings #SSR-307-47. The SumoSprings will offer the same quality as the Timbrens in terms of suspension…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

There's not many differences between the Air Lift WirelessONE item #AL25980EZ and item #AL25980. The main difference is that the item #AL25980EZ has a slightly higher CFM at 1.03 compared to 0.92 and it runs slightly more efficient at 9% over 15%…

view full answer...

Answer 10

If your Ford F-450 has an actual bed and is not a cab and chassis model (with a service bed or flatbed) then you can use the Curt universal folding gooseneck ball rail kit #C61502. You could then use Curt hitch #C-52 or #C65500. A custom hitch for a…

view full answer...

Answer 11

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Answer 12

Thank you for the pictures! For a replacement option I recommend the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout - Bolt On - Disc - 2" Ball - Zinc - 7.5K #DX29FR to replace your current actuator. The #DX29FR has a 7500lb trailer weight…

view full answer...

Installation of Timbren Suspension Enhancement on 1994 Toyota Pickup

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching