Replacement Stromberg Part # SMFP-4400 With 4 Steps

Question

Question:

it stated that the 4 step by stromberg smfp-4400 is the one for my 5th wheel bt when i try to look it up 4400 it comes up it is aflexco . i have a 27 cougar keystone 2015

asked by: Marla S

0

Expert Reply:

The Flexco Manual Pull-Out Steps, part # SMFP-4400, is the replacement that you are looking for. Flexco is a product line of Stromberg Carlson which is why it comes up as Flexco when you were searching.

If you want to double check to make sure that these stairs are the exact replacement, you can refer to the attached picture to compare the mounting holes for these steps to what you have right now on your 2015 Cougar Keystone.

expert reply by: Jon G

0

click to enlarge

Answer 1

If the mounting location for your RV steps is 27 inches wide we have steps that will work for you. I recommend the Stromberg Carlson RV Stairs, part #SMFP-4400. These steps measure 27-inches wide overall, and 12-inches deep (front to back) and 18-1/2…

view full answer...

Answer 2

As long as there is a place for you to securely attach the install bracket of the Brophy RV Scissor Steps #AS24 on your porch these steps should fit and work well. These are designed for 31-39 inch tall setups so your porch being 39 inches tall…

view full answer...

Answer 3

Sounds like you'd want to go with a removable scissor setup like the Brophy Camper Steps part #AS24 which will need to be taken off it's mounting bracket between uses. This will give you total access to your trailer hitch when needed.

view full answer...

Answer 4

Both the Brophy #AS24 and the TorkLift #TLA7804 are easily removed when not in use- and it's actually recommended that you do so. Additionally, they both weigh in around 26-lbs total, so they're easy to move on and off; so they'd both be…

view full answer...

Answer 5

Are measurements are not like lumber measurements that round up. If the overall width of your existing steps is 27-1/2 inches then the Manual Pull-Out Steps #953240RFALC1 are going to be the best option.

view full answer...

Answer 6

Normally the SAE number isn't a reliable way to pick out replacement lenses, but we know that the #A32RB is the correct replacement for a lens marked SAE-A-P2-DOT-02 like what you have. For an all new assembly you'd want the part #MC32RB.

view full answer...

Answer 7

Your G6A-7 is an Atwood water heater with a 1/2" drain plug. If you have aluminum threads I recommend the Camco RV Water Heater Anode Rod w/ Drain - 1/2" Diameter x 4-1/2" Long Item #CAM11533. This is an aluminum plug with an anode rod…

view full answer...

Answer 8

Yes, the Ventline Pinnacle Ducted RV Range Hood with Light #VE98SR can replace your existing High Pointe range hood. This has the same dimensions at 20" wide x 18" deep x 4-3/4" tall. There will be a small difference in the vent…

view full answer...

Answer 9

We certainly have base plate kits available for your 2016 Ford F-150 that will hook right up to your existing Sterling All Terrain Tow Bar #RM-576, but they will all require that you first remove the Ranch Grill Guard that you have mounted. This will…

view full answer...

Answer 10

I reached out to my contact at Lippert and he mentioned that the Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 #LC349975 has holes that are 0.57" diameter and designed for use with 1/2" diameter bolts.

view full answer...

Answer 11

To install the Replacement I-Beam Jack Bracket #LC349975 for Lippert Ground Control 3.0 #LC358590 you'll need to follow the instructions that came with the Lippert Ground Control 3.0. I've attached a cutout from the instructions for the…

view full answer...

Replacement Stromberg Part # SMFP-4400 With 4 Steps

Product Page this Question was Asked From

Continue Researching