How to Determine How Much Fluid Should be Added After Installing Transmission Cooler

Question

Question:

How much transmission fluid do I need to add after installing the D12906 transmission cooler? I dont want to over fill my transmission and I dont want to run it low.

asked by: Cliff T

0

Expert Reply:

What you will want to do is check the transmission fluid level after installing the Derale part # D12906 and then add as much as needed. Most likely around a 1/2 qt would be needed but that will depend too on if you spill any fluid (most do) and how long of lines you use.

expert reply by: Jameson C

0

Answer 1

You will most likely need to add additional transmission fluid when installing a supplemental transmission cooler such as #D13502. The cooler core itself will add capacity and the hose will add some as well. After the cooler is installed and you…

view full answer...

Answer 2

You definitely should get a supplemental transmission cooler as your fluid is getting hot enough while towing that cooling it down will help prolong the life of the transmission. Stacked plate coolers are the most efficient design so I would…

view full answer...

Answer 3

The Derale transmission cooler part #D13403 that you referenced is a stacked plate cooler (the most efficient style) that would do a great job keeping the transmission fluid of your 2004 Chevy Silverado cooler. You'd want to route the fluid…

view full answer...

Answer 4

In order to install the Derale 19-Row Stacked-Plate Transmission Cooler Kit part #D13403 in conjunction with your factory auxiliary transmission cooler on your vehicle, you have two options. You can install the cooler before the factory auxiliary…

view full answer...

Answer 5

According to the owner's manual for your 2003 Chevrolet Suburban with the 5.3L engine and 3.73 gear ratio, the towing capacity of the vehicle is 7,400 lbs if you have a 2WD or 7,100 lbs of you have a 4WD. In order to tow a trailer with your…

view full answer...

Answer 6

The amount of transmission fluid you'd need to add after installing a transmission cooler like the Derale #D13501 really depends but typically it's around 1/2 of a quart. I wouldn't totally adhere to that figure though as the amount that…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

By all accounts the Curt Spectrum Trailer Brake Controller #C51170 works well and is easy to use and install on most vehicles. It is a brand new item so not a lot of feedback has come in on it. I did learn a few things though after speaking with our…

view full answer...

How to Determine How Much Fluid Should be Added After Installing Transmission Cooler

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching