How Many Sets of the Andersen Levelers AM3604 are Needed

Question

Question:

I have a 17 coachmen Catalina legacy edition 283rks. 28ft how many sets will I need and what model number thank you

asked by: Jim

0

Expert Reply:

Just a single set of the Andersen Camper Wheel Chock and Leveler # AM3604 would be all that you would need. In reality it would be just one side of the trailer that would need to be raised so having a set on both sides would not be needed.

expert reply by: Jameson C

0

Answer 1

Light truck tires (LT) are sometimes used in RV applications but generally not on utility trailers. Light truck tires are a type of passenger vehicle tire and as such they are not built with as thick of a sidewall as trailer tires. A thicker sidewall…

view full answer...

Answer 2

Since none of our slip on tow mirrors fit your 2006 Chevy Silverado the best solution we have would be a door mounted tow mirror like the Wheel Master Eagle Vision part #WM6600-2 which would work well. The stability, adjustability, and wide range of…

view full answer...

Answer 3

The best option we have would be something like the Camco Trailer Tongue Jack Stand #CAM44635 or FloTool Wheel Chock and Jack Stand #FT11933MI if you are wanting a way to get more height of your jack since Stromberg does not make an extension foot…

view full answer...

Answer 4

We have just what you're looking for. The Manual-to-Electric Conversion Kit for HappiJac Truck Camper Jack Systems #LC733960-182524 is compatible with your HappiJac 4160 Series jacks and will allow you to convert your system from manual to…

view full answer...

Answer 5

Hello Zach. The TorkLift Tie Downs #TLF2022A and #TLF3008A will work with your 2022 Ford F-350 short bed but the front tie downs will not be compatible with the AMP Research Powered Running Boards as they will get in the way of each other. You would…

view full answer...

Answer 6

The best trailer hitch for your 2024 Subaru Forester is the Curt Trailer Hitch Receiver #C47HR because it's the only option that has the crosstube hidden behind the bumper. This means your hitch looks more sleek and gives you better ground…

view full answer...

Answer 7

I do have a suggestion, because we have a gas strut with with dimensions that are the same as the Stabilus 654150 which is likely to work; the Stabilus strut measures 26.46" when extended with 120 lbs of force. The nearly identical strut we…

view full answer...

Answer 8

The leg length or the depth that the garnish part #2756 has is right at 2 inches. From the picture you submitted it looks like you installed the roof vent part #9106 with the mounting flange on the inside of the trailer. The vent should be installed…

view full answer...

Answer 9

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

view full answer...

Answer 10

Yes, the Replacement Gear Motor Assembly for Lippert Slide-Out #LC27VR is the 385966 that you're looking for.

view full answer...

How Many Sets of the Andersen Levelers AM3604 are Needed

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching