Replacement Bolts for the Thule Adventurer Cargo Box

Question

Question:

Is it possible to just order the bolts from this hardware kit I only need four, and what is the part number?

asked by: John S

0

Expert Reply:

You would need 4 Carriage Bolt M6-1 x 75mm - Fully Threaded, part # TH10403.

These are the replacement bolts that come in the Thule QM3 Quick On-Off Mounting Hardware Kit for Adventurer Cargo Box, part # TH04997.

expert reply by: Jameson C

0

Answer 1

Yes we have exactly what you are looking for. While the old part number 14908 is not available anymore, you will want to go with the updated Replacement Lid Lifter Hinge #TH14936 which is a fit for your Thule Adventurer Roof Cargo Box.

view full answer...

Answer 2

The original hinges or struts are no longer available for the Thule Adventurer cargo boxes but the current ones, #TH14936, will fit and are what you should be using. There isn't a right and left and the orientation should not matter. It sounds…

view full answer...

Answer 3

We do have various replacement u-bolts for Thule Cargo boxes that are available by themselves. However, the original hardware for the Adventurer cargo box is actually #TH04997. For u-bolts we have the following: #TH02943, The center to center…

view full answer...

Answer 4

We do offer the replacement mounting hardware for the Thule Adventurer Rooftop Cargo Box, however the Adventurer was not designed to use U-bolts to mount to the crossbars. The mounting hardware that will replace the original mounting hardware for the…

view full answer...

Answer 5

Testing the brake controller is fairly easy. Sever the blue brake output wire near the brake controller leaving enough room to reconnect it and then apply the manual slide. Using a circuit tester like the Quickee Tester, part #PTW2993, you should get…

view full answer...

Answer 6

It sounds like you are looking for replacement mounting hardware for your Thule Mountaineer Cargo Box. For this you will just need the Replacement QM3 - Quick Mount Hardware #TH04997. This kit consists of the complete mounting hardware set, including…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 12

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...