Replacement Parts for Older Thule Roof Rack Fairings

Question

Question:

Looking for the correct replacement fasteners for my TH872XT Fairing. Thank you.

asked by: Corey M

0

Expert Reply:

If you are looking for the push pin fasteners use # 853-5482. For a replacement bracket use # 853-5477. We also have replacement load bar clip # 8537361 and square bar adapter # 853-7362.

expert reply by: Michael H

0

Answer 1

We have a number of replacement parts available for the Thule M.O.A.B. I have listed out the replacement parts we have available so that you can take a look and select what parts you are needing. - Replacement Washer for Thule M.O.A.B. #951-0614-20…

view full answer...

Answer 2

I'd recommend a panel removal tool, part #ALL648544. Gently wedge the tool under the fastener, and pry gently. If you should happen to damage any of the push in fasteners, we sell replacements as part #853-5482. We also carry the…

view full answer...

Answer 3

The Thule MOAB basket used regular Thule locks. For a 2-pack use #TH450200. These lock sets come with the locks, keys, and the change key to install them. If you have other Thule products and want a lock that uses the same key then I would need to…

view full answer...

Answer 4

The length of the Replacement Tamperproof Bolt for Thule M.O.A.B. Roof Mounted Cargo Carrier, part #853-5269-05, is in fact 1.5 inches, which equates 38.1 mm. In order to install this, you will need the wrench that came with the M.O.A.B. cargo…

view full answer...

Answer 5

We sell replacement hardware for the Thule MOAB cargo basket, but we sell all the parts individually and not as a kit. Here's what we have: Replacement Square Nut #853-5163 Replacement Tamperproof Bolt #853-5269-05 Replacement Washer for…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 9

The Brophy Slide In Camper Tie-Downs #HSAB might be a fit for your 2011 Ford F-150 but you'll need to do a bit of measuring first and you'll likely need to trim out holes where the tie-downs would sit. You'll want to verify that #HSAB…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Replacement Parts for Older Thule Roof Rack Fairings

Products Referenced in This Question

Continue Researching