Replacement Hardware Recommendation for a Thule MOAB Roof Cargo Basket

Question

Question:

Hi - I recently acquired a Thule Moab roof basket no hardware, basket only - I would like to mount this onto a 2002 4runner with factory roof racks. What replacement hardware would I need? Thanks.

asked by: Michael F

0

Expert Reply:

We sell replacement hardware for the Thule MOAB cargo basket, but we sell all the parts individually and not as a kit. Here's what we have:

Replacement Square Nut # 853-5163
Replacement Tamperproof Bolt # 853-5269-05
Replacement Washer for Thule M.O.A.B. # 951-0614-20

expert reply by: Jameson C

0

Answer 1

The Thule MOAB basket used regular Thule locks. For a 2-pack use #TH450200. These lock sets come with the locks, keys, and the change key to install them. If you have other Thule products and want a lock that uses the same key then I would need to…

view full answer...

Answer 2

The 853-5113 part number that you referenced is the FootBase for the TK2 Tracker system. If you just need the FootBase then that would be part #753-2149. I confirmed this with my contact at Thule. If you are needing to replace the Tracker foot…

view full answer...

Answer 3

Thule's TK-1 Kit has been discontinued, but is mostly available as its component parts. I've listed what we have below with the number of each part needed to complete a single bar kit. Base, #753-2149 (2 needed total) Bolt…

view full answer...

Answer 4

The length of the Replacement Tamperproof Bolt for Thule M.O.A.B. Roof Mounted Cargo Carrier, part #853-5269-05, is in fact 1.5 inches, which equates 38.1 mm. In order to install this, you will need the wrench that came with the M.O.A.B. cargo…

view full answer...

Answer 5

If you are looking for the push pin fasteners use #853-5482. For a replacement bracket use #853-5477. We also have replacement load bar clip #8537361 and square bar adapter #853-7362.

view full answer...

Answer 6

Sounds like you're looking for the Replacement Load Bar #853-0182-35. If you need the mounting hardware as well then you'll need 2 of each of the following parts to fit a load bar to your Thule M.O.A.B. roof basket: Mounting Bracket…

view full answer...

Answer 7

The Thule Load Stops for Load Bars #TH503 are 3-1/2" tall and will take up 3" of crossbar space each (see attached photo). I confirmed this with my contact at Thule.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 12

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Replacement Hardware Recommendation for a Thule MOAB Roof Cargo Basket

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching