Landing Gear Moving In Opposite Directions When Switch Is Activated
Question:
Here are pictures of the back of the gear case. Looks like the gear case is made of a hard plastic- it looks like to me one of the plastic knobs which holds the gear case in place has broken off causing the case to move freely. If this is the case - do they sell just the case since the gears are working fine. Please advise- thanks .
asked by: Larry N
Expert Reply:
One of your motors is connected backwards and you'll need to simply swap the wires at the switch assembly # LC145236. Make sure to level your landing gear before you completely finish the assembly because the motors will work in sync with each other when you switch the wires around and you want your landing gear to move at the same rate. To level your trailer, simply unplug one motor and use the other to move up or down to match, then connect the wiring in the correct order to make both legs move up and down together.
Products Referenced in This Question
Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gearbox
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ignition Proof 5th Wheel RV Landing Gear Switch w/Harness
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- Lippert
more information >
Continue Researching
- Shop: Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs
- Video: Lippert Electric Landing Gear Set Review
- Search Results: 235 85r16 load range g
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Shop: Bulldog Tandem Landing Gear Set - Drop Leg - 36" Lift - 8,000 lbs
- Q&A: Troubleshooting Landing Gear Operating Backwards After Installing New Switch
- Search Results: landing gear
- Shop: Suspension Enhancement
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Video: etrailer Landing Gear Set Review
- Q&A: Best Landing Gear Upgrade Options for 5th Wheel Trailer
- Search Results: electric jack
- Shop: Trailer Hitch
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Search Results: electric trailer jacks
- Shop: Trailer Wiring
- Search Results: lc142178
- Shop: Fifth Wheel Hitch
- Video: etrailer Camper Jack - Landing Gear - RVLG-8000 Review
- Shop: RV Jack Pads
- Search Results: stabilizer jacks camper jacks
- Shop: Lippert High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift
- Shop: Gooseneck Hitch
- Search Results: landing gear camper jacks
- Shop: Stabilizer Jacks - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 2
- Shop: Camper Tie-Downs
- Video: Stromberg Carlson Electric Landing Gear Set Review
- Video: Bulldog Camper Jack - Landing Gear - BD500162 Review
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: 5th Wheel Landing Gear Motor Makes Loud Clicking Noise and Will Not Raise Trailer
Larry
1/19/2017
Here are pictures of the back of the gear case. Looks like the gear case is made of a hard plastic- it looks like to me one of the plastic knobs which holds the gear case in place has broken off causing the case to move freely. If this is the case - do they sell just the case since the gears are working fine. Please advise- thanks .