Will Curt Electronic Sway Control System Work With GM Vehicles With Integrated Brake Controller

Question

Question:

Will this electronic sway master work for my twin braked enclosed snowmobile trailer? Also I have a 2013 Yukon Denali XL with the air ride suspension and integrated brake controller from factory.

asked by: Scott

0

Expert Reply:

The Curt True Course Electronic Sway Control System, part # C94VV will work with your enclosed snowmobile trailer.

expert reply by: Jeffrey L

0

Answer 1

Since your Grand Design is going to be well over the 10,000 lb cutoff, the Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System #LC672136 is not going to work, unfortunately. Your best option is to put one Ultra-Fab Power Twin…

view full answer...

Answer 2

The StabiliTrak that's built into your GMC Sierra does the same thing that the Curt True Course Advanced Bluetooth Trailer Sway Control #C94VV does, so you'd have to disable the built in TSC to use it. Since they're the same thing,…

view full answer...

Answer 3

It does; even with a weight distribution with sway control you can add the Curt True Course Advanced Bluetooth Trailer Sway Control #C94VV. Sway control on a weight distribution hitch can be very effective, but even the best hitches rarely completely…

view full answer...

Answer 4

The Curt True Course Advanced Bluetooth Trailer Sway Control #C94VV works better with a weight distribution system. The True Course is more for emergency maneuvers, high winds, semi trucks passing and so on. It is not necessarily designed for minor…

view full answer...

Answer 5

The Curt Electronic Sway Control System part #C94VV plugs into and functions properly with a RV Standard 7-Way plug like the factory plug on your 2009 Sierra 1500.

view full answer...

Answer 6

The fastest powered a-frame jack we offer is the Phoenix Jack part #UF38-944055 that you referenced which can travel 10 inches in just 47 seconds. Depending on where you would mount the battery would determine if you'd need a battery box.

view full answer...

Answer 7

If the third brake light is still flashing with the Pacer Performance 3rd Brake Light Logic Module part #PP20-702 installed then the unit is either installed incorrectly or faulty. I have attached a wiring diagram you will need to look over and make…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The Curt True Course Advanced Bluetooth Trailer Sway Control #C94VV wins for ease of install and it does a really good job but if you were wanting the best sway control that applies the left and right brake assemblies independently the Tuson…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...