Where is Axle Placement on Trailer Measurement Taken From
Question:
When I am measuring for my 60/40 is that from tounge or floor edge
asked by: Troy
Expert Reply:
The 60/40 measurement to use when initially placing axles is from the center of where the ball fits into the coupler to the very back of the trailer.
The center point of your equalizer hanger needs to be located where you will have 60 percent of the frame of the trailer in front of the center of the equalizer hanger and 40 percent behind the center of the equalizer hanger. For example, if the trailers frames length is 18 feet, then the center-line location for the equalizer hanger will be 10.8 feet from the front of the trailer and 7.2 feet from the back.
This is where to start with when picking out axle locations for a tandem axle trailer. You will need to determine the tongue weight of the trailer and then check out the picture I attached if the tongue weight is anything other than 10 percent of the total trailer weight.
Product Page this Question was Asked From
3-Leaf Double-Eye Spring for 4,000-lb Trailer Axles - 25-1/4" Long
- Trailer Leaf Springs
- Double Eye Springs
- 4000 lbs
- 1-3/4 Inch Wide
- 3 Leaf
- 25-1/4 Inch Long
- Painted
- etrailer
more information >
Continue Researching
- Q&A: Determining Correct Length Replacement Leaf Spring
- Shop: Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 1-1/4" Rear
- Shop: CE Smith Front/Rear Hanger Bracket for Double-Eye Springs - Galvanized Steel - Bolt On
- Shop: CE Smith Front/Center/Rear Hanger Bracket for Double-Eye Springs - Galvanized Steel - Bolt On
- Search Results: spring hanger
- Search Results: spring hanger bracket
- Shop: Trailer Hitch
- Search Results: 44649
- Article: Trailer Wiring Diagrams
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Shop: Grease Seals 10-36 (pair)
- Video: Roadmaster Automatic Battery Disconnect Installation - 2020 GMC Sierra 1500
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Shop: Trailer Wiring
- Shop: Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 6,000 lbs
- Search Results: 68149
- Article: How to Choose the Right Trailer Hitch Class
- Video: Lippert Solera Slider Slide-Topper Review
- Shop: Fifth Wheel Hitch
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Search Results: 25580
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Choosing the Right Trailer Wiring
- Video: etrailer Class III Trailer Hitch Installation - 2016 Jeep Cherokee
- Shop: 10-10 Grease or Oil Double-Lip Seals - Qty 2
- Search Results: dust caps
- Shop: Brake Controller
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Wheel and Tire Recommendation For Jet Ski Trailer with Tire Size ST175/80R13
- Search Results: dust cap