Mounting Kit To Attach Older Thule Ski Rack To Factory Crossbars On 2016 Toyota 4Runner

Question

Question:

Hi there - I wanted to confirm that this product 7533998 will work with a 2016 Toyota 4Runner SR5 factory installed roof rack with cross bars. I have a Thule TH725 ski rack that Id like to put on my new car. Will you confirm? Thanks!

asked by: Mark F

0

Expert Reply:

The mounting kit, part # 7533998 is the kit you need to mount your TH725 ski rack to the factory crossbars on your 2016 4Runner. I confirmed this is the kit you need from my contact at Thule.

When installing this kit on your crossbars you will need to use the original nuts that came with your ski rack. If you need replacements you can order part # 853-5439.

expert reply by: Jeffrey L

0

Answer 1

I contacted Thule about your older Ski and Snowboard rack and my contact said that the only replacement mounting brackets available for older racks is the Kit #7533998, that you referenced. They said that this will only fit on the older 724 or 725…

view full answer...

Answer 2

To determine which Thule replacement hardware you'd need we have to know which Pull Top you have. The part #7533998 is for the TH725 and the part #TH7520970001 is for the TH726 both of which are discontinued. Since you said you also need the…

view full answer...

Answer 3

Many of Thule's rooftop ski carriers feature attachments that can accommodate square bars and other shapes including AeroBlade elliptical and many factory crossbars. Thule's SnowPack #TH7324 ski carrier, for example, can fit these various…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

We do not have replacement brackets for these at this time. I can see if Westin has a replacement and get it added to our site but I can tell you it will likely be all of the brackets and hardware. We don't have the ability to order specific…

view full answer...

Answer 9

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 10

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 11

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 12

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Mounting Kit To Attach Older Thule Ski Rack To Factory Crossbars On 2016 Toyota 4Runner

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching