Matched Pair of Optronics LED 7-Function Trailer Tail Lights

Question

Question:

STL8RB Passenger side. What is the code for driver side light? bottom line ........... I want a set of lights 1Left 1 Right

asked by: Martin

1

Helpful Expert Reply:

You can use Optronics Trailer Tail Light # STL9RB as the match for the passenger-side light # STL8RB. These high-efficiency LED lights will provide both brighter output and reduced power demand as compared to standard incandescent lights. Both are stud-mount lights that use a 3-wire design.

expert reply by: Adam R

1

Answer 1

I went out to the warehouse and pulled the Optronics Replacement Side Marker Lens #AL9RB. It measures 2-13/16 inches across, 2-1/8 inches tall, and it is 3/16 of an inch thick. The mounting holes are 2-5/16 inches apart on center. The lens is for…

view full answer...

Answer 2

Left side tail lights have a clear lens on the bottom to light up the license plate. Right hand side tail lights do not. If you were to use the right hand side light, #STL8RB, you would need a separate light to illuminate the license plate. The left…

view full answer...

Answer 3

Entry door locks, like the Bauer Products #BA64FR, typically will have a sticker on the inner handle portion that sits inside your RV, but I have installed a few where they also have the key code on a sticker on the inner components of the handle.…

view full answer...

Answer 4

Trailer fenders are classified by the diameter of the trailer wheels they're compatible with. For instance, the #F008583 fender you referenced works with 13 inch diameter wheels. If you're unsure of the diameter of your wheels, the last two…

view full answer...

Answer 5

I have a solution for you that is a little higher capacity than the #AM10501 that you asked about. You could use the ST235/85-16 tires in a load range G such as #TTWPRG235R16 which is rated for 4,400 pounds at 110 psi. Four of these would have an…

view full answer...

Answer 6

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Answer 7

The Optronics Flexible LED Light Strip #UCL90CB that you referenced does put off a bit off a purplish hue. If you check out the two pictures I attached you'll see what I mean. It still puts out enough light to be useful though so it would work…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

Thank you for the picture that is very helpful since I cannot always see what trailer manufacturers used on their trailers. The LED Combination Tail Light Kit #TLL9RK may be your best option depending on the condition of your current wiring. This kit…

view full answer...

Answer 10

If you are looking at and LED Trailer Tail Light like part #STL8RB, then you will not need a converter to make it compatible with the 4-Way Wiring Harness on your truck. You will need to figure out the wiring on your trailer to make sure that you get…

view full answer...

Answer 11

All you have to do is swap the incandescent bulbs with LED replacement assemblies. Your tow vehicle would not have a problem at all with this switch. In fact, it actually would thank you if it could since now the trailer wiring will draw a fraction…

view full answer...

Answer 12

To add an extra tail light to your trailer, I recommend using a Trailer Tail Light like the Optronics #STL8RB. This light will give you stop light, turn signal light and tail light functions and will mount to any surface using the included studs. You…

view full answer...

Matched Pair of Optronics LED 7-Function Trailer Tail Lights

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching