Replacement Side Rails for TruXedo Lo Pro QT Tonneau Cover on a 2015 Chevy Silverado 2500 Short Bed

Question

Question:

I want to order new siderails for it , will these rails [tx5469] work Thank You

asked by: Steve F

0

Expert Reply:

For your 2015 Chevy Silverado 2500 short bed and TruXedo Lo Pro QT cover, # TX572001, you will need replacement rails # TX5720-SIDERAILS. The ones you referenced will not fit your truck/cover.

expert reply by: Michael H

0

Answer 1

For the Truxedo Lo Pro QT cover part #TX572701 that you have on your 2015 GMC Sierra 2500 with a short bed part #TX572701 the correct replacement rear header is the part #TX5727-RearHeader.

view full answer...

Answer 2

For your 2016 Chevrolet Silverado 1500, the correct replacement tarp is the Replacement Tarp for TruXedo Lo Pro Roll-up Tonneau Cover #TX572701-CVR for your TruXedo Lo Pro Soft Roll-up Tonneau Cover #TX572701.

view full answer...

Answer 3

The bed size for the tonneau covers typically happens at the main selection page when you click on the tonneau cover option for your 2015 Chevrolet Silverado 1500. If you got to the product page through a web search you would have skipped that screen…

view full answer...

Answer 4

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 5

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 6

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Replacement Side Rails for TruXedo Lo Pro QT Tonneau Cover on a 2015 Chevy Silverado 2500 Short Bed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching