Installation Instructions for the Tekonsha Voyager Brake Controller on a 2003 Ford F150 Supercrew  

Question:

Expert Reply:

Yes, I can help you get the Tekonsha Voyager Brake Controller, item # 39510, installed on your 2003 F-150 Supercrew. There are two different scenarios for your vehicle, and the installation will depend on whether you have a factory 7-Way connector installed at the rear of your truck or a factory 4-Way connector installed. We have an FAQ that details the installation instructions for your truck, see link.

If you have a Factory 7-Way you will need to order the Voyager with a Ford brake controller wiring harness, item # 39510-3035-P. The connection point for this harness is under the dash near the center console and there will be a 6-pin connector that mates to the connector on the end of the # 3035-P brake controller harness. Once you have the brake controller mounted and the wire harness plugged inline you will be ready to set up the brake controller with your trailer attached to the OEM 7-Way.

If your 2003 Ford F150 Supercrew does not have the factory 7-way, you will need the same parts as above with the addition of the Ford Replacement OEM Tow Package Wiring Harness, 7-Way, item # 118242. This harness installs inline with the mating plugs found on the inside of the drivers side frame rail at the rear of the vehicle. Once this harness, the Voyager and the under dash harness is installed your wiring will be complete and you can setup the brake controller with the included instructions, see link.

expert reply by: Robert G

0