Recommended Transmission Cooler for 2006 GMC Yukon XL Denali

Question

Question:

Will this fit on a 2006 yukon denali xl I believe it has a 4L65e transmisson? I was looking to do one of these and a front mount trans cooler as well. My trans temp has reached 250 while towing up hill. Thanks

asked by: Joe

0

Expert Reply:

You are wise to install supplementary transmission cooling for your 2006 GMC Yukon XL since transmission fluid temperatures of 250-degrees Fahrenheit will otherwise certainly shorten its lifespan.

I suggest the Derale # D13504, a high-efficiency Class IV cooler, for your 6.0L. You will also need adapter fitting # D13035 to install it. A video is included to show you the process.

expert reply by: Adam R

0

Loai Q.

9/5/2020

Dear , kindly i own gmc 2006 yukon denali , and the transmission oil temperature reaches 250 F , and there is an external cooler radiator , so plz advice . best regards,

Reply

Jon G.

9/8/2020

So your transmission is reaching 250 and you have a supplemental cooler as well? It sounds like you might need to get your OEM and supplemental coolers checked out if they aren't able to keep your vehicle cool enough.

Reply

Loai Q.

9/8/2020

thanks , well the coolers are clean , and its not blocked internally , i mean the oil is circulated through the lines . kindly can i know if there is another thing to be checked for the coolers . thanks

Reply

Jon G.

9/11/2020

@LoaiQ I'm honestly not sure what else you'll need to check. You'll want to have someone who is familiar with transmissions to take a look at what's going on.

Reply

See All (4) Replies to Loai Q. ∨

Answer 1

The round or trunnion bars refers to the end of the spring bars. Round bars are typically designed for lighter applications, are a bit harder to install and are usually priced lower than trunnion bars. Trunnion bars are typically designed to be…

view full answer...

Answer 2

A factory 7-way trailer connector isn't all you need to power a trailer's electric brakes. You still need a brake controller. Some Ford F-150s are equipped with a factory integrated brake controller, which you may have. If your 2012…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 6

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 7

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...

Answer 8

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

view full answer...

Answer 9

I do have a solution for your 2024 Kia Telluride that has the LED taillights that does allow it to have both a 4-way and 7-way plus install a brake controller but it is not with the #TK74CR which does not work for you based on the LED taillights.…

view full answer...

Answer 10

The first thing you will need for your 1999 D250 is a 4-way. The Curt T-Connector Vehicle Wiring Harness #C55317 plugs into the connection points behind your rear bumper and will allow you to power your trailer's signal lights. Once the 4-way is…

view full answer...

Answer 11

For your 2024 Hyunda Santa Cruz we have the Curt 7-way kit part #C68JR that is a confirmed fit. This installs by plugging into a factory wiring connector on your vehicle which means a really easy install that doesn't require any splicing.

view full answer...

Answer 12

Hey Antoine, so the two kits you mentioned are actually really similar and honestly I would go with the part #ETBC7 if I were you. The #ETBC7L is basically the same thing minus a couple wires and breakers so you may as well get the kit that has…

view full answer...

Recommended Transmission Cooler for 2006 GMC Yukon XL Denali

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching