Replacement Motor For Lippert Fifth Wheel Landing Gear

Question

Question:

Is there a replacement motor for the Lippert LC333964 landing gear? Thanks.

asked by: Kevin

0

Expert Reply:

The 12-volt replacement motor for your Lippert landing gear is part # LC217884.

This is a simple installation and easily connects to the power source feeding your landing gear.

A replacement aluminum gearbox is available as part # LG-179015. Even if your current gearbox is still functional, this makes a good replacement for the gearboxes with the plastic housings that didn't hold up very well.

expert reply by: Jeffrey L

0

Answer 1

I have a solution for you but there aren't any replacement motors for the MDP 7119 Atwood Landing Gear Motor. The best option is to replace it with the Lippert Landing Gear - Inside Mount - 5,000-lbs - 19-3/4" Travel - Power Jack item…

view full answer...

Answer 2

To replace your current 125340 motor, you will need the #LG-142178. This will be a direct replacement for your current motor, but you may consider replacing the gear box as well. For that you will need the #LG-179015. These together should get…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 5

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Replacement Motor For Lippert Fifth Wheel Landing Gear

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching