Installation of Hopkins Multi-Tow Wiring Harness for 2010 Toyota Tacoma with Factory 7-Way

Question:

Good morning. I mistakenly purchased the HM43385 for my 2010 Toyota Tacoma. I should still be able to use the HM43385 I will just need to cut of the two connectors and hard wire to the existing wiring. The truck had the factory 7 pin connector but the entire assembly got tore off and was in pieces. Please let me know if this idea will work. Thanks

asked by: Gregg G

Expert Reply:

Yes, you are correct that you can snip off the connectors of the Hopkins # HM43385 and hardwire them to the wiring on your 2010 Toyota Tacoma with factory 7-way connector. You will want to make sure that you match up the wires by function to prevent any issues.

To make these connections, I recommend using heat shrink butt connectors like 12 # DW05745-5 and 16 # 05731-5 and then wrapping them up with electrical tape to prevent any dirt or moisture from being able to get into the connections. I have attached a Help Article and image that indicates the wire gauge for each wire.

I have attached all the above mentioned products to this page for your convenience.

expert reply by: Jackie C