How to Find Reverse Light Circuit on a Vehicle that Has Reverse Lights Mounted in Hatch
Question:
i have a mazda 2012 cx9 ,I purchaced a tow hitch, wireing harness and adapter part #20136 from etrailer. my problem is that the adapter needs to be connected to the reverse lights but the reverse lights are in the rear hatch not the rear side so how do connect the wire from the adapter to them. thanks
asked by: Rob D
Expert Reply:
Between the hatch and the door frame will be a wire loom in a rubber conduit that will be carrying the reverse light circuit. What you will want to do is peal back the conduit so that you can test the wiring there for a circuit with a tester like part # PTW2993 that only sees voltage when the reverse light circuit is activated. Once you find that circuit you will want to trace the wiring back somewhere on the door frame side to a place that allows you to easily access it. Most likely this will be behind some interior panels.
Products Referenced in This Question
Product Page this Question was Asked From
Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 0 - 5 Feet Long
- 4 Flat
- Plug and Lead
- 5 Flat
- Tow Ready
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can a 4-Way Trailer Connector be Plugged Into a 5-Way Vehicle End Trailer Connector
- Q&A: Best 4-Way Trailer Wiring Harness For 2024 Toyota RAV4
- Article: Trailer Tire Sizing
- Q&A: Parts Needed to Install 5-Way on 2019 Toyota RAV4
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Trailer Hitch for a 2024 Toyota RAV4
- Article: Trailer Maintenance Schedule
- Q&A: What Colors are Trailer Brake Magnets Wires
- Q&A: When Using a 5-Way for Tow Bar Wiring Which Pin for a Charge Line Kit
- Q&A: Seal With Dimensions to Replace 171255UC
- Article: How to Choose the Right Trailer Hitch Class