What Size Trailer Tongue Does the Fulton Economy Spare Tire Carrier - Lockable, # FETCLB0201 Fit

Question

Question:

is this lock down for 3 or 4 channel. what is the size of the bottom of the u bolt

asked by: fred w

0

Expert Reply:

The internal width of the u-bolt on the Fulton Economy Spare Tire Carrier - Lockable, # FETCLB0201, is 3 inches, so it will fit on a 3 inch trailer tongue.

expert reply by: Michael H

0

Answer 1

The CE Smith Roller Style Guide-Ons for Pontoon Boat Trailers #CE27672 can pretty easily be used on a tritoon pontoon like what you have.

view full answer...

Answer 2

Yes, the CE Smith Bunk-Style Guide-Ons for Boat Trailers - 60" Long - 1 Pair #CE27600 can work on the inside of a pontoon boat. Based on the photo you may prefer the CE Smith 90-Degree Bunk Board Guide-On Kit #CE27600K90 which will includes…

view full answer...

Answer 3

The CE Smith Bunk-Style Guide-Ons for Boat Trailers part #CE27600 can be used on any trailer but traditionally they are not used on pontoons. Not saying we do not install them on pontoons. As a matter of fact we used the CE Smith Bunk-Style Guide-Ons…

view full answer...

Answer 4

Actually when you use the Fulton Economy Spare Tire Carrier #FETCLB0201 that you referenced you do not use nuts to secure the U-bolt. Each of the brackets are threaded and basically become the nuts that hold the tire to the U-bolt. You will just need…

view full answer...

Answer 5

The Fulton Economy Spare Tire Carrier #FETCLB0201 will measure 9-5/8" long and 4-5/8" wide going outside to outside. This will also fit frames up to 3" wide. I included a full diagram with all measurements for you to take a look at as…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 11

I am sorry I don't have any tires that are going to fit your rim. I do have a couple of comparable size tires that come in a wheel tire combo. I have listed the two below along with their lug patterns. 5 on 4-1/2 Lug Pattern - Kenda 205/65-10…

view full answer...

Answer 12

You can add larger wheels and tires to a trailer as long as you have enough room for the larger size. The main clearance issues we find when putting larger tires and wheels on a trailer is from the top of the tire to the fender and from the inside…

view full answer...