Is Lock Included With Replacement Endcap For AeroBlade Edge Roof Rack Crossbar

Question

Question:

Does the end cap come with the locking screw that locks it in place? Thanks

asked by: Ken

0

Expert Reply:

The # TH1500052333 package has the replacement endcap and does not include a locking screw you asked about.

If you have lock cores on the legs of your roof rack you can order a lock core. Just type THLOCK in the search box with the 4 digits you have on your key, so if you have a key with N003 on it you would type # THLOCKN003 for the replacement core.

If you are looking for the plug that fits in the hole on the replacement endcap that would be part # 8524023006.

expert reply by: Jeffrey L

0

Answer 1

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The brackets on the Thule Hullavator 897 and the Thule Hullavator 897XT are not the same. The first generation Hullavator was designed to only work with Thule square bars, so it will not work with your Thule WingBar Evo. The updated model, 897XT, was…

view full answer...

Answer 4

The inside width of the Yakima SkinnyWarrior Roof Rack Cargo Basket part #Y07014 is 21". Therefore, it could be used to secure the boogie boards.

view full answer...

Answer 5

The Replacement Endcap for Thule AeroBlade Edge Roof Rack - Flush Fixed - Left #TH1500052333 is for the driver side of the vehicle. The lock for this endcap is on the right side. The correct part for the passenger side of the vehicle is the…

view full answer...

Answer 6

We do have replacement end caps for your Thule AeroBlade Edge Roof Rack TH7602-TH7602! The Replacement Endcap - Left is #TH1500052333 while the Replacement Endcap - Right is #TH1500052334. If you take a look at the accompanying photos you will be…

view full answer...

Answer 7

To remove and install the Left Raised Rail Foot #1500052316 from your AeroBlade Edge roof rack all you have to do is remove the torx head screw from the main assembly and the rail foot will slide right off. Attached is a close-up photo of an…

view full answer...

Answer 8

Sounds like you're trying to replace the shank on the original Kuat NV with a 2" shank from the newer NV? No, that will not be possible. There are so many design differences between the two bike racks that a retrofit like that will not work.…

view full answer...

Answer 9

In order to have all your Thule lock cores keyed alike, all the locks should use the same lock core. The number on the lock is the key number. If one of the locks you've got has the number "N082" stamped on it, and you'd like…

view full answer...

Answer 10

For the Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" #C12172, there really isn't a solution other than to use a torque wrench. Without torqing the necessary bolts to the manufacturer specs, you void the warranty and can have…

view full answer...

Is Lock Included With Replacement Endcap For AeroBlade Edge Roof Rack Crossbar

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching