Recommendation for a Front Sway Bar on a 2000 Itasca Sunrise 35 Foot with a P32 Workhorse Chassis
Question:
Is this the correct fit for my 2000 itasca sunrise 35 foot p32 workhorse chassis? it is terrible in the wind,passing trucks excetra. What would you recommend in front sway bar or suspension help?
asked by: Craig S
Expert Reply:
As long as your Workhorse is a widetrack then I would recommend the Roadmaster Front Suspension Bar # RM-1109-200 for your 2000 Itasca Sunrise with a P32 Workhorse Chassis. This anti-sway bar is going to minimize sway and the effects of trucks and wind on your Sunrise. It will improve the stability and driveability of your vehicle which will reduce driver fatigue.
We typically recommend installing one stabilization/sway piece at a time to see how the ride improves before adding more because the more you end up adding the stiffer the ride will end up being and that can also be uncomfortable. Best thing to start with is the anti-sway bar I've recommended above to see if this will not be the perfect solution to your problem.
I have linked the recommended Roadmaster part to this page for your convenience.
Product Page this Question was Asked From
Roadmaster Front Suspension Bar for Motorhomes with Factory Anti-Sway Bar - 1-1/2" Diameter
- Anti-Sway Bars
- Anti-Sway Bar
- Front
- 1-1/2 Inch Diameter
- Steel w Polyurethane Bushing
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Roadmaster Front Suspension Bar for Motorhomes with Factory Anti-Sway Bar - 1-1/2" Diameter
- Shop: Roadmaster Rear Anti-Sway Bar - 1-3/8" Diameter
- Shop: Roadmaster Front Anti-Sway Bar and Bushing Kit - 1-5/8" Diameter
- Shop: Suspension Enhancement
- Shop: Vehicle Sway Bars
- Video: Roadmaster Front Anti-Sway Bar Review
- Shop: Trailer Hitch
- Search Results: 44649
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs - Rear Axle
- Shop: Dust Cap for Kodiak Disc Brake Kit
- Shop: Trailer Wiring
- Search Results: 68149
- Q&A: Does HBA-CAM Adapter Module for Hydrastar Electric Over Hydraulic Brake Actuators have 2 or 4 Wires
- Article: Stability Control for Heavy Duty Vehicles
- Search Results: 25580
- Shop: Roadmaster Front Anti-Sway Bar - 1-3/4" Diameter
- Shop: Fifth Wheel Hitch
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Search Results: dust cap
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Shop: Brake Controller
- Q&A: Hanger Spacing for 3500 LB. Tandem Axle Trailer
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Search Results: dust caps
- Article: Trailer Wiring Diagrams
- Shop: Gooseneck Hitch
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)