Replacement Light And Toggle Switch For Ultra-Fab Electric Jack.

Question

Question:

Looking for light replacements for my Jack. Part number sticker is worn so bad I cant tell which Jack it is I have. Looks like #3502. Lights look like #38-751042 and while Im at it I want to replace the motor switch, #38-751037. Any help would be greatly appreciated.

asked by: Dan W

0

Expert Reply:

If your jack is an Ultra-Fab 3500 Series jack, then unfortunately the jack light is not a replacement part available. However, the replacement Toggle ON/OFF Motor Switch, part # UF38-75-1037 is designed for Ultra-Fab # UF38-944014, # UF38-944016, and # UF38-944017 jacks.

expert reply by: Jeffrey L

0

Answer 1

We do indeed have replacement 20-Amp circuit breakers, like the Pollak Circuit Breaker - Cycling/Automatic Reset - 20 Amp - Straight Mount Bracket #PK54520, but the Auto-Reset Circuit Breaker for Ultra-Fab 3,500-lb Electric A-Frame Jack UF38-101238…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 6

Hi Tom, I have two options to replace the electric tongue jack on your Jayco Whitehawk: Option 1: Electric Jack w/ Footplate #EJ-3520-BBX. This jack is going to be your no-frills 'get the job done' style jack. It has a 3,500lb…

view full answer...

Answer 7

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.

view full answer...

Answer 8

Both of the ARK stabilizer jacks #ARK94FR and #ARK87FR can rotate 90 degrees forward and back so in a way it is 180 degrees like you asked about. The difference is the #ARK94FR has a square tube and #ARK87FR has a round tube. These are both going be…

view full answer...

Answer 9

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Replacement Light And Toggle Switch For Ultra-Fab Electric Jack.

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching