Brake Mounting Flange Availability with 1-3/4 inch Hole for Use with Titan Brake Kit T4843300

Question

Question:

I need two Brake Backing Plate Mount Flange with 1 3/4inch weld on. Do you have any plates available that will work on this Part # T4843300

asked by: Robert W

0

Expert Reply:

The only 4 bolt mounting flange we offer that has a 1-3/4 inch hole in the middle is the part # 4-34 which is designed for 2k rated axles.

expert reply by: Jameson C

0

Answer 1

For a 3500 lb axle, your options for bearing sizes are greatly narrowed down so that makes things a lot easier. You just need to determine your bolt pattern of your wheels. For traditional 5 on 4-1/2 inch bolt pattern, Trailer Hub and Drum Assembly…

view full answer...

Answer 2

Capacity is what will have the capacity as opposed to the spindle, and the correct brake mounting flange will depend on the diameter of your axle. Since you mentioned a 3,500 lbs I assume that is your axle's capacity and typically those…

view full answer...

Answer 3

The 2x2 inch square axle is likely 3,500 lbs or less capacity. I would need more spindle dimensions or bearing numbers to assist. If you pull a hub and measure at the spindle where the bearings and seal ride using the digital caliper like #PTW80157…

view full answer...

Answer 4

That is the correct hole size for brake mounting flange #4-34. That would leave space for an approximate 1/8 inch weld all around the spindle. Because welding on brake flanges is a precision job it is recommended to have a professional welder with…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 7

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 10

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 11

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...