What is the Peterson Round Trailer Tail Light Part # 431800 and # 432000 Constructed Of

Question

Question:

Is the housing made of plastic or metal?

asked by: Hershel

0

Expert Reply:

The housing of the Peterson Round Trailer Tail Light with License Plate Light, 2 Stud Mounting, Left Hand, item # 432000, and right side, item # 431800, is plastic. At this time we do not have a round surface mount light that has a metal housing.

expert reply by: Robert G

0

Answer 1

The handle of the Cam-Action Lockable Door Latch Kit #383200 needs to be welded to a 3/4 inch pipe. The rest of the hardware included with the kit can be bolted to the door. The pipe and the mounting hardware is not included.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

I spoke with our resident Harley guy about what he thought of the B&W Biker Bar Motorcycle Tie-Down System for Trailers #BWMC2301 if he were to use it with his bike. Since the bike frame is designed to support not only its own weight but also the…

view full answer...

Answer 4

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

view full answer...

Answer 5

The Dexter 8-222 model hubs currently on your trailer are designed primarily for mobile home use, and these types of hubs typically use unique bearing combinations that make it really difficult to find full replacement assemblies. Mobile home parts…

view full answer...

Answer 6

I attached a picture that shows how the #SL58W will install on a trailer with a ramp. I used arrows to point out the latches and the holes that it will fit into when folded up and latched. I also attached a picture that shows where you would weld the…

view full answer...

Answer 7

The SuperSprings Custom Suspension Stabilizer and Sway Control Kit #SSA15MXKT will fit your 2004 Chevrolet Silverado 2500HD. These are designed to assist up to 2,600lbs of weight with trucks that have the leaf springs mounted above the axle. This…

view full answer...

Answer 8

We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…

view full answer...

Answer 9

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 10

The "KTC 7600" stamped on the brake pad doesn't look to be a part number, so I can't cross reference it, but we do know you have Kodiak ceramic brake pads. So to determine the correct brake pads, all you need to do is match up…

view full answer...