Largest Roof Rack Recommendation for a 2016 Subaru Outback

Question

Question:

Hi, what is the biggest roof rack we can put on a 2016 Subaru Outback? My wife, an artist, wants to transport 6foot by 3foot display panels to art shows. Thank you

asked by: Jonathan G

1

Helpful Expert Reply:

If you install the Yakima SkyLine Towers, # Y53TR, along with the Round Bar Adapter, # Y03536, and the Landing Pad, # Y00241, then you can install any length of the Yakima round crossbars that you wish. Yakima has a 78 inch crossbars, # Y00411, 66 inch crossbars, # Y00410, 58 inch crossbars, # Y00409, and 48 inch crossbars, # Y00408. It is okay to cut them down to a custom length as well if you feel like one is too long once it is installed.

There are a few things to keep in mind. First, the crossbars can be an overhead clearance hazard if they hang over the sides of the roof too far, so you will want to watch your head when getting in and out of the car. Also, most states have a law that says the crossbars cannot be wider than the widest part of the vehicle. If the crossbars extend past the side of your car and your sideview mirrors, then you could get a ticket from local or state police. Finally, be sure to check your owners manual for the roof weight capacity before loading any cargo. Be sure you do not exceed the vehicles roof weight capacity.

expert reply by: John H

1

Answer 1

There is just a single difference between the Curt and etrailer trailer hitches that fit your 2023 Mercedes-Benz Sprinter 2500 Cargo Van, which is the finish. The Curt has a glossier finish than the matte black finish of the etrailer hitch, so you…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 11

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...