Brake Controller Install Harness Recommendation for a 2007 Dodge Ram

Question:

I own a 20191 iStop brake control from my previous vehicle. I now own a 2007 Dodge Ram 2500 with towing and 7 pin circular connector in bumper. I do not any connectors, wires or cables for the 20191 brake control. Do you make a connector/wire/cable for the 20191 control and my truck? Please advise. Richard

asked by: Richard C

Helpful Expert Reply:

The Draw Tite brake controller you have, which is basically the same as the Tekonsha Primus # TK90160. To install this controller in your 2007 Dodge Ram 2500 that has a factory 7-way will only require the use of the install harness part # 3020-P which has been confirmed as a fit for your truck.

I attached an install video that shows how this harness will install a controller in a similar truck as yours. It would plug right into the back of the controller and then into an install port under the dash of the truck.

expert reply by: Jameson C