Replacement Hub and Drum for Dexter 10K Axles with 008-214-05 Hubs  

The torque spec for the bolt part #7-103 is 106 ft lbs.

If the lift motor will no longer operate with the controller but does when you apply direct 12 volt power then that tells me there is an issues with the control board. The only way to replace the control board on the Fan-Tastic Vent Roof Vent part…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

For your 2017 Honda Accord Hybrid the Curt hitch part #C11496 is a confirmed fit. For a bike rack you will be limited to 2 bikes maximum because the hitches for the vehicle are Class I hitches. I recommend going with a light weight bike rack to…

According to the online owner's manual for the 2018 Ram 3500, the fuses related to trailer lighting and trailer power are below. The fuse location, fuse value and function are listed for you. F81 20 Amp Yellow Trailer Tow Right Turn/Stop Lights…

The spoke with Dexter and the code "D100G" tells me you have two 10,000 lb trailer axles. I have attached some parts you may need for the axle below. Dexter Trailer Hub Drum Assembly (After July 2009) - part #8-430-5UC3 Dexter Trailer Hub…

I am sorry Beth, but we do not offer an equivalent to the AL-KO 5/8 hub assembly #568215. We do carry replacement bearings for this hub with the #TRJM511946 inner bearing and the #JM205149 outer bearing, but we do not offer any hubs that use this…

I reached out to Dexter and found that your axle is a 10,000 lb general duty axle. The correct inner bearing and race is the #387A and #382A, the correct outer bearing and race is the #25580 and #25520. For a replacement seal you want the #10-51. For…