Can a Venture Landing Gear Leg be Greased  

The A-Frame Trailer Jack - Topwind - 5,000 lbs. by Dutton-Lainson #DL22772 does not have a grease zerk fitting integrated, sor do any of our other top wind jacks. This doesn't mean they are difficult to maintain, but they do not have that…

The various 2008 Keystone Fusion toy haulers have published shipping weights in the 12K-12.5K range so the 8000-lb rated landing gear set #RVLG-8000 is rated adequately. I checked the specs for these models but no specifics about the OEM landing gear…

I attached a picture that shows where the zerk fitting for greasing the Lippert landing gear part #LC179013 is, but if your landing gear does not have any fittings best bet would be to take off the top (if possible) and apply grease to the bevel…

The distance you mentioned between your landing gear weld stops is not a standard distance so while we can help you get a new set that will fit, you will have to have the brackets on the trailer frame moved to accommodate the new landing gear. The…

I have a few different options for you depending on the route you would like to take. However, regardless of which route you pursue you will need to take some measurements of your outer jack tube length and weld stop spacing. If you are handy and the…

Most fifth wheel landing gear is standard size these days. I recommend the Lippert lead leg #LC179013 and follower leg #LC179014 to replace the legs on your Fulton system. This can be used with the Replacement Aluminum Gearbox for Stromberg Carlson…

We don't have anything with the weld stops at the precise points of your current legs. I recommend using the Replacement Lead Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2" #LG-179013 and follow leg #LG-179014. These will be…

The correct replacement follow leg you are looking for is the part #LG-179014. This matches the part numbers and dimensions you mentioned as well.

If you have a Venture landing gear set on your 2006 Keystone Cougar the Stromberg Carlson repair kit part #LG-146059 would be the correct kit for you. As you take the jack apart you should be able to see how it all comes apart and reinstalls with the…

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

I went to the warehouse and took some measurements of the Replacement Lead Leg, part #LG-177202 for you. I have attached a photo of the leg with the measurements noted. From the top of the leg to the top of the upper bracket is 7 inches. To the top…

In order to find the correct replacement landing gear leg for your Open Range 430RLS 5th wheel trailer I would need to know the brand and part number of the landing gear leg you currently have on your trailer. These should be stamped or etched into…