How to Remove Old Motor and Install New Coach Step Motor for Lippert Electric Steps

Question

Question:

I want to make sure I correctly install the motor. Can you provide some installation instructions? The blog response I read said Instructions were attached, but I couldnt find them.

asked by: Michael

1

Helpful Expert Reply:

I will be happy to help explain how to remove the old motor and install the new one # LC301695.

The motor and gear assembly can be replaced by first disconnecting the two pin connector from the module to the motor.

Next, remove the p-clamp holding the wire harness to the motor mount.

Then, remove the ball joint linkage from the gear followed by the self-tapping screw that holds the ground wire.

Next, remove the 3 bolts that hold the motor mount to the step base. Care should be taken not to disturb the adjustment in the length of the ball joint linkage. Install the new motor # LC301695 using the above steps in reverse order.

expert reply by: Michael H

1

click to enlarge

Answer 1

Sounds like you are looking for the Replacement Self-Lubricating Bushing for Lippert Electric Coach Step #LC116531 which does not come with the gear part #LC369354 that you referenced.

view full answer...

Answer 2

That is a strange issue to have. The issue may be with one of a few parts. It could be that the motor is stuttering before the steps are fully retracted causing them to retract as it thinks that it may be hitting something. The controller may be…

view full answer...

Answer 3

When installing the new replacement motor, part #LC301695, it is best to have the steps extended. With the steps extended it will give you more room to work with for the installation.

view full answer...

Answer 4

The 171317 steps are no longer being manufactured, but we do have a replacement gear plate as part #LC301696, motor part #LC301695, and controller part #LC301702.

view full answer...

Answer 5

The Atwood GE16EXT 10 gallon water heater has 23.5" x 19.4" x 18.2" dimensions so you'll have to make alterations to the cutout hole to fill in the gap from any of the water heaters we carry. I recommend the Furrion…

view full answer...

Answer 6

From what I can find the dimensions of the Apollo Halftime RV Microwave AAC240TRB are 12" T x 20.6" W x 20.5" D. If this is the case with yours then the closest option we have available size-wise would be the Furrion…

view full answer...

Answer 7

I do have an option for you but we currently do not carry the correct replacement for your Coach Step Model 168367. Instead, I recommend repairing the steps you have now as this will be much more cost effective and won't require any drilling.…

view full answer...

Answer 8

The correct replacement circuit and control board for your Lippert Electronic leveling system is the Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System #LC421484. This will be a plug and play solution, so…

view full answer...

Answer 9

The correct replacement motor for your Coach Steps is the Replacement Motor for Lippert Electric Coach Step part #LC301695.

view full answer...

Answer 10

Since Atwood went out of business back in 2016 there are no longer any "direct" replacements available for their water heaters. Dometic bought their water heater line and slowly cut away every model so we're left trying to find the best…

view full answer...

Answer 11

The number ( 411 D) you provided doesn't correspond with a Fan-Tastic Vent roof vent model number, but if yours uses the remote control #FV9068-09 that you referenced, that tells us it's a 7350 Series Fan-Tastic Vent Roof Vent, like…

view full answer...

How to Remove Old Motor and Install New Coach Step Motor for Lippert Electric Steps

Product Page this Question was Asked From

Continue Researching