Replacement Weight Distribution Chain Kit for Reese or Draw-Tite 1,200 Pound Spring Bars

Question

Question:

will these work with a reese 12000 dist bar set up? my bars look like they have two different sizes bolts hole per bar?

asked by: Van

0

Expert Reply:

Replacement weight distribution hardware kit # 66014 fits Reese and Draw-Tite systems that have spring bars that hang from chains. Bars do indeed have 2 different sized holes at the ends. I have included a picture that shows the two different holes sizes for you.

expert reply by: Michael H

0

click to enlarge

Answer 1

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

I reached out to my contact at Reese and the Replacement 1/2" Hardened Washer for Reese Weight Distribution Systems #3306 you were looking at are the correct washers to adjust the hitch ball angle on your Reese Pro Round Bar Weight Distribution…

view full answer...

Answer 6

The spacer washers you mention, for your Pro Series Weight Distribution System #PS49901 (NLA), are 1/2", and have an outer diameter of 1". We do carry them, and you can get them here #3306. If you also need a replacement pin, you can get it…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

While Reese does not offer replacement spring bar retainers for their Weight Distribution Hitch 49912 #RE94FR, I do know some have used the Curt Spring Bar Retainer #17109 to replace them. These have a very similar design to hold the retainer pin in…

view full answer...

Answer 9

If your bars are labeled as Draw-Tite then the system is probably fairly old. There have been changes made to the heads over the years and the new bars will not fit in the old head. To change the bars you would also need to change the head with…

view full answer...

Answer 10

What's the diameter of the shaft where your current springs are installed? If they are 1-1/2 inches you could install the part #RS16933LH and #RS16933RH instead of what you have now and you'd have a much more powerful spring. But if the shaft…

view full answer...

Answer 11

I have a solution to get your Mastercraft boat trailer up and running again, but unfortunately we don't have a cross reference chart for parts for Reliable surge brake actuators. Manufacturers of surge brake couplers simply didn't make these…

view full answer...