Replacement Hub Recommendation for Trailer with .99 inch Bearing ID Surface Dimension
Question:
Looks to be pretty close to what I have, can you please confirm. My hubs and bearings on the trailer I just bought where badly corroded so I was unable to find / read any numbers off of what I have. I have the measurements listed below, any help would be greatly appreciated. OD of both races are 1.980 Inner diameter of both bearings are 0.995 Bearing section on the spindle measured 1.00 The seal section of the spindle is 1.240 OD of the seal measured at the back of the hub was 1.973
asked by: Mike
Expert Reply:
Based on the dimensions that you listed your trailer has the BT8 spindle on it. That would mean that the hub part # CE13100 that you referenced would fit it and work well.
Product Page this Question was Asked From
CE Smith Trailer Hub Assembly w/ Carrying Case for 2,500-lb Axles - 4 on 4 - Pre-Greased - Threaded
- Trailer Hubs and Drums
- Hub
- Pre-Greased
- Standard
- L44643
- L44643
- For 2500 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- CE Smith
more information >
Continue Researching
- Shop: CE Smith Trailer Hub Assembly w/ Carrying Case for 2,500-lb Axles - 4 on 4 - Pre-Greased - Threaded
- Q&A: Torque Rating For the Four Bolts On The CE Smith Trailer Hub # CE13100
- Video: CE Smith Trailer Fenders - Top and Side Step - CE19503 Review
- Search Results: thule trailer parts
- Search Results: knott hub
- Search Results: fenders
- Search Results: fender
- Search Results: hub
- Shop: 23x47 Carpod Walled Cargo Carrier w/ Lid - 2" Hitches - Steel - Folding - 450 lbs
- Shop: Fulton Single Axle Trailer Fender with Top and Side Steps - White Plastic - 13" Wheels - Qty 1
- Shop: CE Smith Single Axle Trailer Fender w/ Top and Side Steps - Black Plastic - 13" Wheels - Qty 1
- Shop: CE Smith Single Axle Trailer Fenders w/ Top and Side Steps - Black Plastic - 13" Wheels - Qty 2
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - L44643 Bearings - Pre-Greased
- Shop: CE Smith Trailer Hub Assembly w/ Carrying Case for 2,500-lb Axles - 4 on 4 - Pre-Greased
- Search Results: ce19503
- Search Results: 25580
- Shop: Trailer Hitch
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Video: Choosing the Right Trailer Wiring
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Shop: Brake Controller
- Video: Choosing the Right Brake Controller
- Article: Most Popular Wheel Bearings
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: etrailer Trailer Idler Hub Assembly Review and Installation
- Article: Trailer Tire Sizing
on Trailer Hubs and Drums
