Repair Kit for Venture Landing Gear Lead or Follower Legs 900-40RU

Question

Question:

I need a rebuild kit for my fifth wheels landing gear. The part number Venture gave me as a replacement is 900-40RU and 900-40LU. I need to know which rebuild kit I can use.

asked by: Brooke G

0

Expert Reply:

I spoke with my contact at Lippert who acquired Venture and he said that repair kit # LG-146059 is the correct kit for lead leg and then part # LC146060 for the follow leg.

expert reply by: Jameson C

0

Answer 1

The only follow leg I can recommend you use with your Venture landing gear would be the part #LC179014. Stromberg Carlson makes the Venture landing gear, that is the brands are different but the jacks are the same. I cannot recommend you install a…

view full answer...

Answer 2

According to my contact at Stromberg Carlson, their #LG-179014 follower leg would indeed be an acceptable replacement for your Venture #900-40L if the 29-1/2 inch outer tube and overall heights of 33-1/2 match your existing jack. You can see these…

view full answer...

Answer 3

Your trailer likely uses an Atwood or Lippert landing gear set up so you could replace the lead leg with a model from one of those manufacturers. Most landing gear major components on newer 5th wheel trailers are interchangeable if you get the right…

view full answer...

Answer 4

I went out to our warehouse to take a look at the Replacement Follow Jack w/ Drop Leg #LG-179014 that you mentioned. The leg itself does indeed have a length of exactly 29-1/2 inches. The distance between the welded tabs, inside to inside, is right…

view full answer...

Answer 5

We can help you determine the correct replacement landing gear for your Monta Vista, though landing gear is a universal type of fit, and there isn't specific landing gear that fits your trailer. So in order to determine the correct replacement…

view full answer...

Answer 6

We do have the correct 29-1/2 inch replacement legs for Venture landing gear, which is the following: - Replacement Lead Jack with Drop Leg #LG-179013 - Replacement Follow Jack with Drop Leg #LG-179014

view full answer...

Answer 7

To determine the correct replacement landing gear for your 5th wheel trailer, you will need to measure the mounting brackets on your trailer from the underside of the top bracket to the top of the lower bracket as shown in the diagram. From there you…

view full answer...

Answer 8

Replacement landing gear leg #LG-179013 fits landing gear set #LG-1 and #LG-183708. The size of 5th wheel trailer landing gear is pretty much all the same. Some install differently than others. This particular type requires brackets welded directly…

view full answer...

Answer 9

You will either need to connect to your truck or have another stabilizer to support the weight when you remove the landing gear. The lead or follow leg can then be removed by loosening the welded brackets that hold the leg in place and move them…

view full answer...

Answer 10

I spoke with my contact at Stromberg Carlson and the Replacement Lead Jack with Drop Leg, #LG-179013, is the same part as the Lippert Universal Fit Lead Landing Gear, #179013. The only difference between the two products is that they are sold through…

view full answer...

Answer 11

Since your Venture leg is the follow leg the repair kit is #LC146060. If you had the lead leg it would be #LC146059.

view full answer...

Answer 12

It sounds like the gearbox could be bad or possibly the motor, this could be easily confirmed by removing each of the components (gearbox/motor) and testing them separately. The gear boxes are luckily pretty standardized and not terribly expensive,…

view full answer...

Repair Kit for Venture Landing Gear Lead or Follower Legs 900-40RU

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching