Mounting Hole Spacing for the Single-Bottle Liquid Propane Gas Rack # 2020-JR

Question

Question:

What is the distance between the mounting holes on part #2020-JR?

asked by: Jonathan

1

Helpful Expert Reply:

I went out into our warehouse to grab a Single-Bottle Liquid Propane Gas Rack # 2020-JR and measure and found that the distance between the two mounting holes is 9 inches.

expert reply by: Jameson C

1

Answer 1

I really like the solar powered LED Porch Light for RVs #DG0132 which mounts to the side of your RV and gives you a light that's motion activated, is waterproof, and since it's solar powered it provides it's own power source.…

view full answer...

Answer 2

I spoke with my contact at Stromberg Carlson and it sounds like the Single-Bottle Liquid Propane Gas Rack, #2020-JR, will work great for you. This rack can be mounted to a flat surface on the interior or exterior of your trailer to keep the tank…

view full answer...

Answer 3

Yes if you used a self-tapping screw like the part #FA1131822 you could use it to ground trailer wiring to a frame. Sometimes aluminum trailer frames aren't quite adequate so you may need to run a jumper wire to the main ground wire of the…

view full answer...

Answer 4

I believe I have exactly what you are looking for if you want to keep your current steps. It is the Camco Adjustable Height Platform Step - Aluminum - 19" Long x 14-1/2" Wide - 1,000 lbs, #CAM43676. This adjustable locking step legs…

view full answer...

Answer 5

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a…

view full answer...

Answer 6

The light that indicates that the 12 volt circuit is hot is normal and it will not drain the battery. Think of it as the battery having a really long positive terminal that just extends to the rear of the vehicle. If nothing is drawing power from…

view full answer...

Answer 7

Changing the polarity of the MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-06401K would likely burn out the circuit board. The #MA00-06401K is designed to move air out of your trailer when the vent cover is open or pull air in and circulate the air…

view full answer...

Answer 8

The original Atwood manual crank you are looking for is no longer available but we have the Replacement Crank Handle for Stromberg Carlson Landing Gear #LG-119226 that will work for your Atwood Electric Jack. This is a much longer option which would…

view full answer...

Answer 9

The Ultra-Fab T-Slot Power Drill Adapter for Scissor Jacks #UF48-979071 will have a slot that is 1/4 inch wide and although not intended for your topwind trailer jack could maybe work. I've attached a picture that has several dimensions for you…

view full answer...

Answer 10

Our customers have told us that the #LG-119226 Replacement Crank Handle works with most Atwood landing gear. I've linked to a product description video featuring the replacement handle. I've also provided a close-up photo showing what the end…

view full answer...

Answer 11

Sure thing! The MaxxFan Roof Vent w/ 12V Fan #MA00A04301K is actually exhaust only. However, if you're wanting the exhaust & intake version, then you'll want the: -MaxxFan Plus Roof Vent w/ 12V Fan and Thermostat #MA00-04000K.

view full answer...

Mounting Hole Spacing for the Single-Bottle Liquid Propane Gas Rack # 2020-JR

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching