How Long is the Camco Dual Flush Pro for Rinsing RV Holding Tanks and Sewer Hoses

Question

Question:

I would like to keep this valve on the trailer since the original valve no longer seals completely. So I know if it will protrude past the edge of my trailer I need to know how long it is.

asked by: Steve

0

Expert Reply:

I went out to our warehouse and pulled Camco Dual Flush Pro # CAM39062 to measure the length for you. The overall length from end to end is 8-5/16 inches. I have included a picture showing where I measured.

expert reply by: Michael H

0

click to enlarge

Answer 1

The Camco Dual Flush Adapter #CAM39072 is going to mounted pretty far from the opposite end of the holding tank so you would need a good amount of water pressure to effectively rinse all areas of the tank. It may not be enough to clear out clogs. For…

view full answer...

Answer 2

The end of the Valterra Waste Valve for RV Black Water Tank #T50B that has the lugs has a 3" diameter but the other side with the threads is actually designed to fit over a 3" diameter threaded sewage pipe which is why it measures…

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 5

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

So I have your hub narrowed down to a few different possibilities but we need to know what your bolt pattern is to know for sure. We have the part #84556UC3 for if your bolt pattern is 5 on 5 inch. We have the part #845476UC3 for if your bolt pattern…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

Blue Ox has an easy system for determining the weight capacity of your spring bars, whereas other companies may use measurements or printed capacity to assist. With Blue Ox, there is a 5 dimple system: No dimples means it is rated for up to 350 lbs…

view full answer...

Answer 10

To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of battery…

view full answer...

Answer 11

Hey Scott, so since you have a Dometic AC unit currently the replacement you'd want is the Advent Air part #ACDOM150 which was designed to replace Dometic units which means a really simple install that allows you to use current wiring and…

view full answer...

Answer 12

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

How Long is the Camco Dual Flush Pro for Rinsing RV Holding Tanks and Sewer Hoses

Product Page this Question was Asked From

Continue Researching