Front Hitch Recommendation for a 2013 Ford E-450 RV

Question

Question:

Hi sirs. Please let me know if the front hitch Code 65053, fits on my Ford E450 2013 Coachmen RV. Best regards,

asked by: Jorge A

0

Expert Reply:

Yes, the Draw Tite hitch part # 65053 that you referenced has been confirmed as a fit for your 2013 Ford E-450 RV Cutaway so it would work well for you.

expert reply by: Jameson C

0

Answer 1

You will need to use a hitch mounted motorcycle carrier like the Ultra-Fab #UF48-979033 to carry your Honda Trail 125. This is required due to the weight of the Honda at roughly 250lbs. A bumper mounted rack like the Swagman #S64663 is only rated…

view full answer...

Answer 2

The only trailer component that determines the speed rating of the trailer is the tires. All you have to do is simply replace your current tires with one that is rated for highway use, like the Kenda Loadstar #AM3S120 that you referenced, and you…

view full answer...

Answer 3

First let's make sure that this carrier #e96ZR will fit your RV. This carrier would fit 4" x 4" and 4-1/2" x 4" RV bumper. I think that this will work well for you, but tying your bikes down on their side…

view full answer...

Answer 4

The 24x84 etrailer Cargo Carrier for RV Bumper part #e96ZR can hold a spare tire but there isn't any sort of specific mount for this. The photo attached below is a custom job from a neighbor and I'm not totally sure what they used to create…

view full answer...

Answer 5

The reason that some hitch-mounted accessory items, whether a motorcycle, cargo or bicycle carrier, cannot be used on the rear of an RV or trailer has to do with stress forces on the rack. With most RVs there will be a greater distance from the rear…

view full answer...

Answer 6

Yes, the Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets #MO34VR are included with the 24x60 etrailer Cargo Carrier for RV Bumper #e99049. The supports are not included in the instructions assembly drawing as it not always able to be…

view full answer...

Answer 7

As far as mounting your 472-pound motorcycle along with the 52-pound Ultra-Fab Dirt Bike Carrier #UF48-979033 on your hitch rated for 500-pound hitch, you should definitely upgrade the hitch. This is because it is extremely dangerous to exceed the…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

If you have the Ford 3" hitch then you can definitely add it but, yes it would change the weight capacity. The TorkLift Cannon Hitch Extension item #TLE1636 only has a 3,600 lbs towing capacity and a 360 lbs maximum tongue weight. If used with a…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Front Hitch Recommendation for a 2013 Ford E-450 RV

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching