Replacement Trailer Tire ST205/75D/15 to Replace 11 Year Old Tire

Question

Question:

I have a pair of 11 yr. old trailer tires size ST205/75D/15 tires that have very few miles on them and look new. Trailer has been kept garaged. Do you think these tires are still good and safe to pull? I need too go on a 225 mile round trip and come back with a load. I dont want to buy new tires if these will work for me. Thanks,

asked by: Kermit V

1

Helpful Expert Reply:

Typically trailer tires are only good for 7 years. If yours are 11 years old I would strongly recommend you replace them.

For new tires I would recommend the # TTWTRTM2057515C as these are radials in the same size as you have.

A radial tire flexes more than a bias tire, giving it better ground contact, traction, stability, and tread wear.

A radial tire will normally run cooler than a bias ply tire, especially when the tire is under a load. A tire that runs cooler will last longer.

expert reply by: Jameson C

1

Answer 1

Even when stored in the somewhat controlled environment of a garage, tires are still subject to dry rot and flat spotting. Even if the tire tread has plenty of depth left and you can't see any cracking with the naked eye, the generally accepted…

view full answer...

Answer 2

For a tandem axle trailer rated for 7000 lbs, you can use either a Load Range C or D tire. Each axle will be rated for 3500 lbs so you need a tire that will carry 1/2 that capacity. That would make your minimum load range before limiting your system…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Replacement Trailer Tire ST205/75D/15 to Replace 11 Year Old Tire

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching