How to Remove Rear Appearance Panel Rivets for Hitch Install on a 2015 Toyota RAV4
Question:
How do I remove the fasteners that hold the drivers side panel on 2015 Rav 4 ? It has screwsinch that I am not familiar with. This plastic panel covers the tie down bracket which needs to be removed. Thanks
asked by: Don
0
Expert Reply:
The rivets that are used to hold the appearance panel that are in the picture I attached can be removed by inserting a slot screwdriver under the center round piece and then twisting it so that it pulls down from the outer piece. Once it has slid out partially it will remove from the panel.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 525 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: 2017 Toyota RAV4 Trailer Hitch and Wiring Recommendations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Q&A: Recommended Hitch and Wiring Harness for a 2017 Toyota Highlander
- Q&A: Comparing the Curt Hitch C13416 and EcoHitch Hitch 306-X7396 for a 2019 Toyota RAV4
- Q&A: Trailer Hitch Recommendation for 2017 Toyota RAV4 Hybrid
- Article: How to Choose a Hitch-Mounted Bike Rack
- Q&A: What is Required for Trimming the Panel on my 2018 Toyota Rav4 to Fit the Curt Hitch
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Most Popular Wheel Bearings
- Article: How to Choose a Bike Rack That Will Clear a Rear Mounted Spare Tire or Bumper