How Do You Know How Many Ultra-Fab RV and Motorhome Leveling Blocks to Use

Question

Question:

How do you know how many blocks to stack to attain level? Is it by trial and error?

asked by: Tom

0

Expert Reply:

You're correct, you'd need to use trial and error. However, you could use a leveler like part # HM09615, which would eliminate a lot of guesswork and eyeballing.

expert reply by: Mike L

0

Answer 1

The Ultra-Fab leveling blocks #UF48-979051 are designed for leveling trailers and RV's and the reason they are quite rigid on top and extremely durable. I called our representative at Ultra-Fab and there isn't any type of top cap available.…

view full answer...

Answer 2

Thanks for the photos and information - that always makes things easier on our end! We do have a handful of replacement pin boxes that fit in place of your Lippert Rhino Pin Box. Since you don't think you'll want/need the air bag kit I…

view full answer...

Answer 3

Thank you so much for the pictures! That is exactly what I need. Your 2023 Solitude 2930RL has what's called a Lippert Rhino pin box. The Rhino Box, like the Lippert 1621 you mentioned, is a specific bolt pattern and to replace it with a MORryde…

view full answer...

Answer 4

Yes, the 7-Way Vehicle Power Adapter #FR87PR will allow your Furrion camera system to operate correctly. Your 2023 Chevrolet Tahoe uses a Pulse Wave Modulation for the trailer lights to be able to detect errors with the trailer lighting. The adapter…

view full answer...

Answer 5

Yes, you are going to need the 7-Way Vehicle Power Adapter for Furrion RV Observation Camera #FR87PR. The main issue was with 2019 and up Chevy/GM vehicle's not supplying enough constant power to the Furrion cameras, however we did also notice…

view full answer...

Answer 6

With the GVWR of your 2024 Brinkley MODEL Z 3100 5th wheel being 14,995lbs the MORryde Cushioned 5th Wheel Pin Box for 18K to 21K Trailers w/ Lippert Rhino #MR55QR would be a compatible fit, but give you a bad ride quality because the shear spring is…

view full answer...

Answer 7

The reason you're having this issue is because the middle jacks on the Lippert Ground Control 3.0 (6 point set) #LC675817 aren't designed to be run independently and will only come down after auto-leveling has been completed. There is not a…

view full answer...

Answer 8

They easiest way I've found to operate the legs of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 is with the Lippert OneControl monitor if your trailer has it installed. This monitor will allow you to select…

view full answer...

Answer 9

The best chock/leveling system we have for your motorhome with a dually axle is the Andersen Camper Wheel Chock and Leveler part #AM3604. This system can be used on trailers/vehicles up to 30,000 lbs with wheels up to 32" diameter. They are made…

view full answer...

Answer 10

To answer the last question first, a stabilizer jack such as #JSC-30 would be used until there was just enough tension to keep the trailer or RV from rocking. For actual lifting you would need a different device. So assuming that the RV was level…

view full answer...