Section Width for the Kendra Loadstar Tires and Wheels

Question

Question:

what is the width of this tire / rim combo? When mountede on a small cargo trailer is it suitsable for highway travel?

asked by: Greg

0

Expert Reply:

The section width of the Loadstar ST205/75D15 Bias Trailer Tire w/ 15" Black Mod Wheel - 5 on 4-1/2 - Load Range C # AM3S664DX that you referenced is 7.7 inches. These tires are approved for use on the highway so they should work very well for you. They are rated for speeds up to 81 mph.

This wheel and tire combo meets DOT specifications and exceeds FMVSS.

expert reply by: Jameson C

0

Answer 1

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 4

Tire designations ST205/75D14 and ST205/75R14 are both for special trailer tires with a 205mm width, 75-percent aspect ratio and that fit a 14-inch wheel. The difference between them is the tire's type of construction. The ST205/75D14 tire is a…

view full answer...

Answer 5

No, the smaller Loadstar ST205/75D15 Bias Trailer Tire w/ 15" Black Mod Wheel item #AM3S664DX would not be a viable option as a spare tire. It's almost 1-1/2" smaller then the Taskmaster ST235/75R15 Radial Off-Road Tire w/ 15" item…

view full answer...

Answer 6

The tire/wheel combination products that we offer come from the manufacturer already pre-mounted. The tire's low spot is matched to the rim's high spot when they are mounted together. This is not the same as an actual dynamic tire balancing…

view full answer...

Answer 7

The difference between the letters D and R on a trailer tire size is to show the different tire's construction. D stands for bias ply and R for radial. The main difference between a radial ply and a bias ply tire is how the tire is constructed.…

view full answer...

Answer 8

The Torflex Lift Kit item #K71-707-01 is the correct kit for a #10 Dexter torsion axle and you won't need to drill any new holes into the spacers. I have attached a couple of pictures below so you can see how they look once installed. I have also…

view full answer...

Answer 9

I went and pulled a Kenda ST205/75D15 Bias Trailer Tire with 15" Black Mod Wheel #AM3S664DX from our warehouse and measured it from the mounting flange out to the furthest point out on the tire and I measured 4 inches. You want about 2 inches…

view full answer...

Answer 10

Karrier and Loadstar are two different brand names used by Kenda. There's no difference in quality or function between the two brand names. For a ST175/80-13 Radial trailer tire in load range D, I'd recommend part #AM10210 if you're…

view full answer...

Answer 11

The Loadstar ST205/75D15 Bias Trailer Tire w/ 15" Black Mod Wheel #AM3S664DX needs to be inflated to it's max psi rating of 50 psi when cold. If you use lower psi you'd lower the weight capacity of the tire and cause heat to build up…

view full answer...

Section Width for the Kendra Loadstar Tires and Wheels

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching