How to Wire Up an Adapter to Tow Trailer for Motorcycle that has a 5-Way
Question:
i need trailer light kit for 2014 miata mx5 with a 5 pin connector, my Trailer i pull with a honda gold wing motorcycle, the trailer is 5 pin . i dont want change the trailer. so i can use with both vehicles
asked by: Randy
Expert Reply:
Normally, the 5 wire flat connector will accept a 4 wire flat connector and work properly. The extra circuit on the 5 wire connector is normally wired to power a reverse lockout or electric trailer brakes not the brake lights. If your motorcycle has the brake light circuit connected to the extra circuit you will need to do some re wiring or install a converter, item # 119178KIT, on the motorcycle.
Your trailer should be wired as follows. White wire = ground, brown = tail light, yellow = left turn and brake, green = right turn and brake. If the brown tail light wire is carrying the brake circuit something is wired incorrectly. You will need to use a circuit tester, item # 3808, to determine what is wrong on the trailer.
Once the trailer is working correctly you can wire the # 119178KIT converter on the motorcycle to reduce its 5 wire system to a 4 wire system. Attach the white ground wire to a suitable ground on the motorcycle chassis. Use a circuit tester to find the tail light circuit and attach the brown wire. Next, find the brake signal and attach the red wire to this circuit. Find the left and right turn signal wires and attach the yellow and green wires to these respectively. You will then have a properly functioning 4-Way at the rear of the motorcycle.
The only other way to make the 5 wire system on the motorcycle work with the trailer would be to attach a 5-Flat Trailer End Harness, item # 20017, or the 4 Pole to 5 Pole Trailer Wiring Adapter, item # 47515, to the trailers wiring and use the blue wire and the brake light wire and attach two more brake lights, item # MCL44RB, for the blue wire to power.
Products Referenced in This Question
Tekonsha Tail Light Converter with 4-Way Flat Trailer Connector and Install Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 1-1/2 Feet Long
- Universal Fit
- 4 Flat
- Tekonsha
more information >
Adapter 4-Pole to 5-Pole Trailer Wiring Adapter - Shorter
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 4 Flat
- Plug and Lead
- 5 Flat
- Hopkins
more information >
Optronics LED Trailer Clearance or Side Marker Light w/ Reflex Reflector - 6 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 4L x 1-1/2W Inch
- Red
- Optronics
more information >
Product Page this Question was Asked From
5-Flat Trailer End 48" Harness
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 5 Flat
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Q&A: Recommended 5th Wheel Hitch for a 2023 GMC Sierra 3500 with OEM Prep Package
- Q&A: Adapting a 7-Way to a 4-Way On a 2012 Honda Pilot for Thule Arcos Enclosed Cargo Carrier # TH25YE
- Q&A: Replacement Hubs for a 1998 Tracker TrailStar Boat Trailer
- Q&A: Drum Brake Replacement Assemblies for Use with Titan Actuator
- Q&A: Parts Needed to Add 5-Way to 2023 Toyota Tacoma
- Q&A: Recommended Grease Caps for 2.04 Inch Diameter Hub Bore on Trailer
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement Seal For A Tri Tec T-23972 Seal
- Article: Trailer Lighting Requirements
- Article: Where to Position the Trailer Axle?
- Article: Slipper Spring Trailer Suspension System Review