What is the Mounting Hole Pattern for 7-Way Bracket # 18138

Question

Question:

What is the bolt pattern for mounting the 7-way socket?

asked by: John

0

Expert Reply:

The Draw-Tite bracket for 7-way # 18138 will mount at a right angle with pre-drilled mounting holes. The hole diameter, which will fit the majority of 7-way connectors, is 2-1/16 inches.

I went to our warehouse to get this part and provide you the measurement of the mounting hole bolt pattern and several other measurements.

Take a look at the diagram I made for you.

expert reply by: Chris B

0

click to enlarge

Answer 1

The Mounting Hardware for Command Electronics Multipurpose LED Light #328-19-9 comes with two screws.

view full answer...

Answer 2

The wires of the connector on the part #WG54006-046 are sealed and there isn't a way to remove them. If you check out the diagram I attached, you can see how the pins of the connector are organized.

view full answer...

Answer 3

Yes, the tech note you referenced for the Curt Trailer Hitch Receiver #13445 is meant to take you to either the No-Drill Mount for Electrical Mounting Bracket - Short #18140 or long #C57202. These no-drill brackets have a hose clamp that will wrap…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Just a single difference exists between the Curt and etrailer trailer hitches for your 2024 Mercedes Sprinter 2500 with a factory step bumper, which is the finish. The etrailer hitch has a matte black finish, while the Curt hitch has a glossy black…

view full answer...

Answer 6

There is a trailer hitch receiver that fits your 2024 Mercedes-Benz Sprinter 2500, made by Curt. The correct part number is the following: - Curt Trailer Hitch Receiver #C13388

view full answer...

Answer 7

You're right, there are two 4-way trailer wiring harnesses that fit your 2024 Ford Bronco, so the correct fit for yours will depend on if your Bronco has LED taillights or not. So you will need one of the following: - WITHOUT LED Taillights: Curt…

view full answer...

Answer 8

Yes, the Universal Installation Kit for Trailer Brake Controller item #ETBC7 does fit the 2021 Ram ProMaster 1500 so long as you have a 4-way wiring harness installed like the Curt T-Connector Vehicle Wiring Harness item #C58DR. The item #ETBC7 kit…

view full answer...

Answer 9

I would be happy to help you find a hitch receiver for your 2021 Mercedes-Benz Sprinter 2500 van with a factory step. In order to haul a trailer you are going to need a wiring harness as well. The Curt item #13358 you were looking at is the best…

view full answer...

Answer 10

If you have a 2003-2006 Toyota Tundra the 7-way wiring harness part #HM43385 that you referenced would essentially be the exact same thing as going with the Toyota brand connector. Most likely the Toyota connector does not have the 4-way option that…

view full answer...

Answer 11

DOT 3 or DOT 4 brake fluid is recommended for Demco brake actuators like the #DM72VR. You should never use DOT 5 as it will wear out seals very quickly.

view full answer...

What is the Mounting Hole Pattern for 7-Way Bracket # 18138

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching