Power Steering Cooler for a 2007 Honda Odyssey

Question

Question:

Will this fit a 2007 Honda Odyssey?

asked by: Dave

1

Helpful Expert Reply:

Power steering coolers, including # D13310, are not vehicle specific. So you can use this cooler, or any one that will fit in the available space under the hood, on your 2007 Honda Odyssey!

expert reply by: Michael H

1

Answer 1

The choice of power steering cooler for your 2005 Honda Odyssey will depend on the amount of room you will have to mount the heat exchanger on your vehicle. The power steering cooler will be installed inline with the power steering pump and the…

view full answer...

Answer 2

When installing a power steering cooler like #D13200 on a vehicle that has a factory power steering cooler, the best thing to do is install the supplemental cooler in line with the factory cooler. What you will do is find the return line from the…

view full answer...

Answer 3

Many car manufacturers will state that a transmission cooler and/or power steering cooler is needed when towing in order to protect the transmission and power steering pump when under load and to be in compliance with warranty requirements. It is…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

We actually have a variety of brake components here at etrailer.com that I have linked for you to filter through. Usually what we see is that it's more cost-effective to replace the entire brake assembly instead of piecing it out plus you…

view full answer...

Answer 6

I have attached a great article at the bottom of this page that details all the components needed to install electric brakes on a trailer. The particular parts you need will depend on the camper's axle capacity along with the inner and outer…

view full answer...

Answer 7

You will need two of the 7 inch electric brake assemblies, one right hand, #23-48, and one left hand, #23-47. You will also need an appropriate length of 10 gauge wire, item #10-2-1, for running the wires to the trailer connector at the trailer…

view full answer...

Answer 8

The trailer hitch I recommend for your 2008 Honda Odyssey is the Draw-Tite Max-Frame #75270 because it doesn't require any fascia trimming (like the etrailer and Curt might). This, as well as the other trailer hitches, exceeds the weight ratings…

view full answer...

Answer 9

Any time a vehicle is not moving or if there is extra weight in the vehicle or because the vehicle is towing it makes it harder for the power steering components to do their job (because of the extra weight or lack of motion). This extra stress…

view full answer...

Answer 10

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

view full answer...

Answer 11

If your races are #L44610, which they almost certainly are, you will want the following parts: Bearings: Inner bearing: #L44649 Outer bearing: #L44649 Grease seal: #10-9 Outer diameter: 1.987" Inner diameter: 1.5" Grease cap: 1.986"…

view full answer...

Answer 12

From my research on the forums, it looks like your 1997 Jayco 1207 Pop-Up Camper may have came with 20.5x8-10 tires. The modern equivalent to this size is a 205/65-10. If this is the case then I recommend the Loadstar K399 Bias Trailer Tire part…

view full answer...

Power Steering Cooler for a 2007 Honda Odyssey

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching