Could the Camco RV Drain Trap part # CAM37262 Work on a 1-1/2 inch Drain

Question

Question:

will this part fit directly on the sink drain basket assembly i have an 1 1/2inch drain

asked by: John D

0

Expert Reply:

The Camco RV Drain Trap, part # CAM37262 is designed for 3/4 inch diameter drain hoses.

The threaded inlet portion of the trap measures 1-3/4 inches at the threads as shown in the attached photo. If your drain hose is 3/4 inches in diameter I am sure you could make this work for you. You may have to enlarge your drain to get this to fit and replace.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Camco RV Drain Trap part #CAM37262 that you referenced attaches directly to the sink. If would replace any style of trap that you have installed currently. You could use a basket strainer with this as long as it would fit it's 1-3/4 inch…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

The brake controller port on a 2021 Ford F-150 (if equipped) will be located behind the coin tray in the center console. This will be accessed by removing the panel under the steering wheel. I have attached a video which shows this below. For a brake…

view full answer...

Answer 7

The 520EM925AWWKIT trim kit included with the High Pointe Standard RV Microwave #HP39ZR is approximately 20.75” W x 15” H.

view full answer...

Answer 8

The overall height of the Camco RV Sink Trap part #CAM37262 is 3-3/4 inches.

view full answer...

Answer 9

The MORryde Generator Tray - 15-3/4" x 16-1/4" #MR99RR is 16-1/4" in length x 15-3/4" wide. I've attached a diagram that will show you all of the dimensions of this generator tray.

view full answer...

Answer 10

Thanks for the picture! Yes, you can use the NOCO Genius Smart Battery Charger item #329-GENIUS10 to charge your two interstate RM27 Interstate marine batteries over winter and it is the correct size for your batteries. It will lower the charging…

view full answer...

Answer 11

I was able to track down an online version of the owner's manual for your 2004 Yukon Denali and it listed the following wiring configuration for the factory 7-Way harness at the bumper: Yellow: Left Stop/Turn Signal Dark Green - Right Stop/Turn…

view full answer...

Answer 12

The Camco RV Drain Trap #CAM37262 or #CAM37420 is designed to be used with a 1-1/2 inch - 11.5 threaded drain fitting. I recommend the Valterra Sink Drain with Strainer Basket #A01-2011VP or the LaSalle Bristol RV Drain with Strainer Basket - Metal -…

view full answer...

Could the Camco RV Drain Trap part # CAM37262 Work on a 1-1/2 inch Drain

Product Page this Question was Asked From

Continue Researching