Cable Lock Recommendation that is 6 Feet Long and 1/2 inch in Diameter

Question

Question:

Can this be had in 6foot x 5/8inch or 6foot x 3/4inch diameter size?

asked by: Paul M

0

Expert Reply:

The closest thing we have to what you are looking for is the Masterlock Quantum Cable Lock part # 8122D which is 6 feet long and is 1/2 inch in diameter.

I attached a review video for you to check out as well.

expert reply by: Jameson C

0

Answer 1

Honestly, it would be pretty easy for someone with bolt cutters to cut through the cable lock you mentioned, #e98891. Locks in general are not a guarantee against theft, but a deterrent. If someone is determined to take your personal belongings, a…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 6

I definitely understand being a bit overwhelmed by the amount of options in front of you, however I can definitely help with differentiating the trailer hitches for your 2019 Subaru Outback Wagon along with explaining my personal recommendation,…

view full answer...

Answer 7

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 8

I would discourage the use of an adapter for use of 2 inch accessories in 1-1/4 inch trailer hitch receivers. The reason is that the adapter places the carrier farther away from the rear of the vehicle and hitch, creating additional torque that 1-1/4…

view full answer...

Answer 9

Generally speaking wheel mount only bike racks are preferred. Especially for people with carbon fiber bike frames since frame mounts aren't recommended at all with them otherwise damage could occur. For other frame designs people still prefer…

view full answer...

Answer 10

The Kuat NV 2.0 2 Bike Platform Rack, #NV22G, and the Kuat NV 2.0 Base 2-Bike Platform rack, #BA22B. are both very similar bike racks. Both racks can be expanded to a 4-bike rack, #NA22G add-on for the NV 2.0 and #BA02B for the NV 2.0 Base, and both…

view full answer...

Answer 11

That all depends on the style of bike you're going to be using. The Hollywood Racks Destination Bike Rack for 2 Bikes item #HLY94FR you were looking at is a great option for bikes with alternative frames and fenders. It uses padded cradles with…

view full answer...

Answer 12

Without knowing how far your hitch sticks out from your Airstream trailer and how wide your handlebars are I can't give you a yes or no answer but I can provide some measurements that will allow you to. From the hitch pin hole to the center of…

view full answer...

Cable Lock Recommendation that is 6 Feet Long and 1/2 inch in Diameter

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching