Is Welding Required to Install Dexter Over-Under Conversion Kits
Question:
Is this a bolt on application or will the spring seats require welding?
asked by: Neal
0
Expert Reply:
It is recommended to tack weld the new spring seats into place but a complete weld job is not required when installing the over-under conversion kit # K71-385-00.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: Trailer Tire Sizing
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Recommended Suspension Enhancements for a 2022 Grand Design Imagine 2910BH
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Article: Slipper Spring Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Is it Possible to Raise Suspension of Trailer that Has Slipper Springs
- Q&A: Installation of Dexter Kit # K71-385-00
- Q&A: Do Spring Seats Have to Be Welded to Install Axle Over Under Kit
- Q&A: Replacement Leaf Springs and Wet Bolt Kit For a 2007 Fleetwood Redline 33 Toyhauler