Replacement Drop Leg for a Bulldog Powered Trailer Jack

Question

Question:

I bent my jack the motor is still good only used it 2-3 times. can a new leg be purchased to put my motor head on?

asked by: Bill H

0

Expert Reply:

Yes, the replacement drop leg is part # BD500190, and is what you need for your Bulldog powered jack # BD500187. I called our representative a Bulldog to confirm as well.

It will include the drop leg and pin.

It's always a good idea to double-check if any of the other components are damaged, or attachment points show any signs of stress from the incident. If that's the case, the jack may need to be replaced.

I included an installation video and information article for you too.

expert reply by: Chris B

0

Answer 1

I checked with Bulldog and for the Bulldog trailer jack part #BD500199 that you referenced the correct replacement drop leg is the part #BD500190.

view full answer...

Answer 2

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 5

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 6

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…

view full answer...

Answer 7

Yes, you can! So long as our Kenda Loadstar 5.30-12 Bias Trailer Tire with 12" White Wheel item #AM30820 is the same size and bolt pattern as what's on your Ironton trailer it can be used not only as a spare but also on your trailer with the…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Replacement Drop Leg for a Bulldog Powered Trailer Jack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching