Weight Capacity of Stromberg Carlson Stake and Grill

Question

Question:

Can you tell me aproximetly how much weight this grill will support? The gentalman on the video indicated that you could put a pot or kettle on it so I was curious.

asked by: Mike9408

1

Helpful Expert Reply:

I spoke with my contact at Stromberg Carlson and he said the Stake and Grill, # GR-1522, that you referenced is grill is heavy duty enough to hold a pot of coffee or about 5 lbs. The product is not designed to carry the load from cast iron skillets.

I have included a product demonstration of the stake and grill for you to checkout.

expert reply by: Chris O

1

Answer 1

I do have an option for you but we don't offer any replacement parts for the Stromberg Carlson Stake and Grill part #GR-1522 except for the Replacement Storage Bag for Stromberg Carlson Stake and Grill part #SC36MR. I'd recommend a complete…

view full answer...

Answer 2

I spoke with my contact at Stromberg Carlson and he said the Stake and Grill set, #GR-1522, is heavy duty enough to hold a pot of coffee or about 5 pounds of weight. But it is not designed to carry the weight of heavy cast iron skillets. The Camco…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

While I cannot determine exactly what leaf springs you need I can tell you your Dexter 5,200lb axles uses the Bearing Kit #BK3-300 for each hub. If you can provide me with the serial number on the axles you have I can contact Dexter to verify the…

view full answer...

Answer 6

A cover is available for your Truxedo LoPro QT, it is Replacement Cover for TruXedo Lo Pro QT Soft, Roll-up Tonneau Cover - Black, #TX569101-CVR. This replaces the tarp on your TruXedo Lo Pro QT soft, roll-up tonneau cover #TX569101. It does require…

view full answer...

Answer 7

You would need to go by the wiring color guide you have found on your truck. Sometimes we see vehicles use different wire colors than what they commonly will use for a variety of reasons, but since your brake controller wiring comes with a list of…

view full answer...

Answer 8

Your Torsion axle simply has integrated suspension into the axle. It is no different than having a trailer with constant weight on it like a travel trailer to have your 1500 lb UTV stored on it. Your axle is rated at 3500 lbs so it won't be an…

view full answer...

Answer 9

You were on the right track. To raise the tires off the ground for long term trailer storage, the best way is to use your front jack to raise the trailer then place the jack stands under the frame by each axle on all four sides. I have attached a…

view full answer...

Answer 10

Take a look at the diagram I provided, which shows the bolt sizes included with the hitch. Four 1/2-13 X 1-3/4 carriage bolts are included, and the other two bolts that are used are preexisting on the vehicle- they're used to hold the bumper…

view full answer...

Answer 11

Yes, the Curt Trailer Hitch Receiver item #C15324 will fit your 2003 GMC Yukon. Depending on your trim package and how low it goes below your bumper you may have to cut an opening in your trim for the receiver to be accessed.

view full answer...

Weight Capacity of Stromberg Carlson Stake and Grill

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching