Weight Capacity for the Trailer Valet Trailer Jack # STC-V21

Question

Question:

What are the weight limitations for the Trailer Valet Swivel Jack?

asked by: Dick M

0

Expert Reply:

The Trailer Valet Trailer Jack # STC-V211 that you referenced has a 500 lb tongue weight rating.

Check out the review video I attached for more information.

expert reply by: Jameson C

0

Answer 1

If the incline is slight and the gravel isn't super deep the Trailer Valet XL part #TVXL25 would work. But if you have a steep driveway and/or deep gravel the wheels of the Valet are going to spin. In the video I attached a link to we show the…

view full answer...

Answer 2

We actually carry a few different document holders for your to choose from for your trailer. Here is a list you can choose from. Peterson Certificate Holder #PM46 Buyers Products Document Holder for Trailers #3375201100 Peterson Certificate Holder…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

You wouldn't want to try and move a trailer up an incline with the MT70881. The dolly itself would be fine but you would most likely not be able to pull that heavy of a trailer up an incline. And then if you somehow did get it going up the…

view full answer...

Answer 6

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 7

I would be happy to! The bottom of the foot to the center of the pipe mount is 10-1/2" when retracted and 24-1/2" when fully extended on the Trailer Valet JXS Trailer Jack w/ Footplate and Drill Powered Option item #TV64FR. Sorry I do not…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 12

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...