Loctite Sleeve Retainer 640 - High Strength/High Temp - Green - 0.20-Fl Oz Tube

Loctite Lubricants Sealants Adhesives - LT37424

Liquid sleeve retainer, or bearing mount, strengthens the fit between non-threaded, smooth, cylindrical assemblies that rely on tight clearances and friction to maintain the connection. Designed for high-temperature and close-fit applications.

Features:

• Creates a tighter fit and prevents slippage when applied to non-threaded, smooth assemblies
• Withstands higher temperatures than other bearing mounts - up to 400 F
• Designed for tight clearances
• Prevents treated parts from corroding
• Requires heat and, for the tightest fits, a press or puller to disassemble
• Made in the USA

Specs:

• Application: press-fit or slip-fit assemblies with clearances to 0.007" diameter
• Quantity: 0.20-fl oz tube (6 mL)
• Sheer strength: 3,000 psi
• Fixture cure (time required to become tacky): 1 hour
• Full cure (time required to reach full set): 24 hours
• Temperature range (endurance limits of threadlocker): -65 F to 400 F

• Bushings
• Bearings
• Oil seals
• Ring gear bolts and differential lock pins
• Cylinder sleeves
• Valve guides
• Valve seats
• Woodruff keys
• Gears
• Pulleys
• Liner assemblies

The following diagrams illustrate the use of Loctite sleeve retainer. Arrows on the gear and shaft illustration show the effects of heating and cooling. The parts can be assembled more easily if the gear is heated or the shaft cooled to make a looser fit between the two parts.

Loctite Sleeve Retainer 640 liquid is applied to the surfaces of parts to be joined. By filling up empty space (microscopic voids) on the surfaces of the parts, the sleeve retainer increases the area of contact between them, creating a tighter fit and preventing slippage.

Withstands temperatures up to 400 F, whereas standard anaerobic bearing mounts withstand temperatures only up to 300 F.

To disassemble, heat to 500 F (requires about 5 minutes with a torch) to loosen the sleeve retainer; then remove while sleeve is still hot, using a press or puller, if necessary.

This sleeve retainer is anaerobic (hardens in the absence of air) and requires contact with an active metal to cure. Active metals (those that tarnish, corrode or rust) include brass, copper, bronze, iron, soft steel and nickel. If both parts to be joined are made of inactive materials, Loctite Klean 'N Prime primer must be applied to one of the surfaces for curing to occur. Inactive materials include plated parts, stainless steel, galvanized steel, magnetite steel, pure aluminum, titanium, magnesium, gold, silver, plastic, cadmium, Iconel, zinc, natural or chemical black oxide and anodized aluminum.

Klean 'N Prime can speed the cure rate of Sleeve Retainer 640. This is especially helpful when you are applying the sleeve retainer to any material, active or inactive, in colder temperatures (below 70 F). Klean 'N Prime also improves the performance of the sleeve retainer in applications with larger clearances by filling some of the space between parts.

Note: If used with Klean 'N Prime primer, sleeve retainer may reach fixture cure in 30 seconds; in this case, it is essential that parts be assembled quickly.

This product is OEM specified: It is approved to meet specifications of original equipment manufacturers.

487235 Loctite Sleeve Retainer 640 - High Temperature

Alternate part number: 37424

Installation Details