Fender Trim Specs:
Features:
...Easy, bolt-on installation with included hardware Specs: Quantity: 4 fender flares 1-Year limited warranty 867981 Rampage Trail Flares Fender Flares for Jeep - Steel - Front and Rear...
Installation Notes:
Drilling may be required for installation
More Information >Videos
for Fender Trim
Help Articles
for Fender Trim
Expert Answers
for Fender Trim
No, I am sorry as there isn't a base plate that I can guarantee would also fit with this grille guard. Often they will be using the same space or attach in the same places. What type of bumper does your Jeep have? I am happy to recommend a…
view full answer...Hi Dave, The etrailer Invisible Base Plate Kit #e98948 and Blue Ox Base Plate Kit #BLU53FR are designed slightly different, but both are compatible fits for your 2023 Jeep Gladiator. The #e98948 is going to be an easier installation since you…
view full answer...Hi Richard! It sounds like you're needing to install the Load Resistor Kit for LED Turn Signals #DI34ZR on the turn signals you've installed on your toolbox. Since LEDs don't require as much power as incandescent bulbs,…
view full answer...Hey Dave, In my opinion the etrailer Invisible Base Plate Kit #e98948 is going to be the stronger option compared to the Blue Ox Base Plate Kit #BLU53FR. Blue Ox started adding safety cables to their baseplate kits as a last resort backup in the…
view full answer...For your 2015 Jeep Wrangler Unlimited Sahara we have the Rampage Mass Articulation Front Recovery Bumper #RA88509 that fits which has 1-inch D-rings so you could use the D-Ring adapter part #BX88358 with your Blue Ox tow bar.
view full answer...For your 2022 Jeep Wrangler, the twist locks (the base plate tabs) will indeed connect to the end of the arms on the etrailer SD Non-Binding Tow Bar #e34ZR. You'll connect that directly to the Invisible Base Plate Kit #e98948. It's somewhat…
view full answer...The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.
view full answer...I must recommend that you replace the hub/drum as well when changing the size of your braking assemblies because the surface area on the old drums may not line up with the new braking assemblies which is why I recommend replacing both at the same…
view full answer...Great question. As a general rule, when your trailer is loaded to it's full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender.This should give you adequate clearance for…
view full answer...The 205/75-15 Tire and Wheel Combo, #AM32395, is 8.1 inches wide and 27.3 inches tall. An F78-14 tire and wheel will be about the same width but it will be 1 inch shorter. I have included a link to a tire size FAQ article that should help.
view full answer...Our largest wheel and tire we carry I recommend using for the Timbren Axle-Less Trailer Suspension #A20RS545 is the Karrier ST205/75R15 Radial Trailer Tire with 15" Aluminum Wheel #KE27JR. This is our largest wheel diameter with the 5 on…
view full answer...I do have an option for you but roof rails won't work very well on a teardrop trailer, even if you were able to get the rails to conform, it's likely the accessories would bind due to the steep angles. Instead, you will need to use artificial…
view full answer...Filter Products (2)